Home › Engine / Hybrid System › 1VD-FTV (ENGINE CONTROL) › ECM › from 2017.01
RM25T0E _51 Engine / Hybrid System _029760 1VD-FTV ENGINE CONTROL _0135352 ECM A

1VD-FTV ENGINE CONTROL  ECM  REMOVAL  


PROCEDURE

Hide 1.CHECK FOR COMPENSATION CODE

NOTICE:

When the ECM is replaced, all of the existing injector compensation codes must be input into the new ECM and the learned value of the supply pump assembly must be input.


a.

Using the GTS, check that the ID codes registered in the injector assemblies installed on each cylinder match the ECM.

If the codes do not match, correct the registered data and recheck the problem symptom by following the steps below.

Click hereEngine / Hybrid System>1VD-FTV (ENGINE CONTROL)>ECD SYSTEM>PRECAUTION

i.

Using GTS, manually correct the registered ID code.

Click hereEngine / Hybrid System>1VD-FTV (ENGINE CONTROL)>ECD SYSTEM>PRECAUTION


ii.

Check if the same symptom occurs, when the vehicle was brought in.

HINT:

If the symptom does not occur, the problem may be caused by misregistration of an ID code.




Hide 2. PRECAUTION

NOTICE:

After turning the ignition switch off, watching time may be required before disconnecting the cable from the battery teminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 89661 4.REMOVE ECM

A163692C01
0.583,0.75 1.583,0.75 true 1.635,0.656 1.969,0.896 0.333,0.24 10 false *a 0.198,0.323 0.396,0.51 0.198,0.188 10 false *b
*a Lock
*b Push


a.

Raise the 2 levers while pushing the locks on the 2 levers.


b.

Disconnect the 2 connectors.

A388453C01
0.042,0.031 0.344,0.25 0.302,0.219 12 false *A 3.583,0.042 3.865,0.271 0.281,0.229 12 true *B 4.604,0.76 4.865,0.969 0.26,0.208 10 false 90° 0.896,0.75 1.156,0.958 0.26,0.208 10 false 90° 0.917,1.823 1.177,2.031 0.26,0.208 10 false 90° 4.594,1.802 4.854,2.01 0.26,0.208 10 false 90°
*A for LHD *B for RHD


NOTICE:

Make sure that the lock levers are raised 90° as shown in the illustration before disconnecting the connectors. Failure to do this may cause the connectors to break.



c.
A388454C01
0.031,0.031 0.292,0.25 0.26,0.219 12 true *A 0.052,2.469 0.323,2.698 0.271,0.229 12 true *B
*A for LHD
*B for RHD


Remove the 4 bolts and ECM.


d.

Remove the gasket.

i.
A167150

Peel off the gasket.


ii.
A167151

Spray gasket remover or equivalent on the remaining tape of the gasket.

NOTICE:

When using gasket remover or equivalent, cover the connector with a cloth.



iii.

Remove the tape of the gasket without using bladed objects.