DTC output mode is set by connecting terminals TC and CG of the DLC3.
DTCs are output by the blinking of the SRS warning light.
When each warning light continues blinking, a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in each ECU is suspected.
A DTC output mode signal is transmitted through the CAN communication system to each ECU, including the airbag sensor assembly. Thus, when all systems do not enter DTC output mode, there may be a ECM malfunction.
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When disconnecting the cable from the negative (-) battery terminal while performing repairs, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
After replacing the airbag sensor assembly, refer to initialization.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
Check if a CAN communication DTC is output.
for LHD: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (for LHD with VSC)>DIAGNOSIS SYSTEM
for RHD: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (for RHD with VSC)>DIAGNOSIS SYSTEM
| Result | Proceed to |
|---|---|
| DTCs are output (for LHD) | A |
| DTCs are output (for RHD) | B |
| DTC is not output | C |
A
B
C
| *A | for RHD |
| *B | for LHD |
| *a | Front view of wire harness connector (to ECM) |
| *b | Front view of DLC3 |
Turn the ignition switch off.
Disconnect the connector from the ECM.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I17-13 (TC) - A29-27 (TC) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I17-13 (TC) - I84-27 (TC) | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Front view of DLC3 |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I17-4 (CG) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *A | for RHD |
| *B | for LHD |
| *a | Front view of wire harness connector (to ECM) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A29-27 (TC) - Body ground | Always | 10 MΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I84-27 (TC) - Body ground | Always | 10 MΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG