When an open or short circuit is detected in the transponder key amplifier coil built into the transponder key ECU assembly, the transponder key ECU assembly stores this DTC.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| B2784 | Antenna Coil Open / Short | The antenna coil in the transponder key coil is open/shorted (1 trip detection logic*1). |
·
Harness or connector
·
Transponder key coil
·
Transponder key ECU assembly |
DTC Output Confirmation Operation:
Insert the key into the ignition key cylinder. |
*1: Only output while a malfunction is present.
| Vehicle Condition when Malfunction Detected | Fail-safe Operation when Malfunction Detected |
|---|---|
| Engine cannot be started | - |
| DTC No. | Data List and Active Test |
|---|---|
| B2784 | Antenna Coil Status |
If the transponder key ECU assembly is replaced, refer to Service Bulletin.
After repair, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".
Clear the DTCs.
Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>IMMOBILISER SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>IMMOBILISER SYSTEM>DTC CHECK / CLEAR
Before checking for DTCs, perform the "DTC Output Confirmation Operation" procedure.
DTC B2784 is not output.
| Result | Proceed to |
|---|---|
| B2784 is not output | A |
| B2784 is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Check that the connectors are properly connected to the transponder key coil.
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>IMMOBILISER SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>IMMOBILISER SYSTEM>DTC CHECK / CLEAR
Before checking for DTCs, perform "DTC Output Confirmation Operation" procedure.
DTC B2784 is not output.
| Result | Proceed to |
|---|---|
| B2784 is not output | A |
| B2784 is output | B |
A
B
Using an oscilloscope, check the waveform.
| *a | Component with harness connected (Transponder Key Coil) |
*b | Waveform 1 |
| *c | Waveform 2 | - | - |
| Item | Content |
|---|---|
| Tester Connection | L59-1 (ANT1) - Body ground |
| Tool Setting | 20 V/DIV., 2 s./DIV. |
| Condition | Within 3 seconds of inserting key into ignition key cylinder |
| Item | Content |
|---|---|
| Tester Connection | L59-5 (ANT2) - Body ground |
| Tool Setting | 20 V/DIV., 2 s./DIV. |
| Condition | Within 3 seconds of inserting key into ignition key cylinder |
Waveform is similar to that shown in the illustration
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the L30 transponder key ECU assembly connector.
Disconnect the L59 transponder key coil connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L30-4 (ANT1) - L59-1 (ANT1) | Always | Below 1 Ω |
| L30-15 (ANT2) - L59-5 (ANT2) | Always | Below 1 Ω |
| L30-4 (ANT1) - Body ground | Always | 10 kΩ or higher |
| L59-1 (ANT1) - Body ground | Always | 10 kΩ or higher |
| L30-15 (ANT2) - Body ground | Always | 10 kΩ or higher |
| L59-5 (ANT2) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the transponder key ECU assembly with a new one.
Refer to Service Bulletin.
Key ID code registration is necessary when replacing the transponder key ECU assembly.
Refer to Service Bulletin.
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>IMMOBILISER SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>IMMOBILISER SYSTEM>DTC CHECK / CLEAR
Before checking for DTCs, perform the "DTC Output Confirmation Operation" procedure.
DTC B2784 is not output.
| Result | Proceed to |
|---|---|
| B2784 is not output | A |
| B2784 is output | B |
A
B