This DTC is stored when a key with a different vehicle serial number is inserted into the ignition key cylinder.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| B2795 | Unmatched Key Code | A key with a different vehicle serial number is inserted into the ignition key cylinder (1 trip detection logic*). |
·
Key
·
Transponder key ECU assembly |
DTC Output Confirmation Operation:
Insert the key into the ignition key cylinder. |
*: Only output while a malfunction is present.
| Vehicle Condition when Malfunction Detected | Fail-safe Operation when Malfunction Detected |
|---|---|
| Engine cannot be started | - |
| DTC No. | Data List and Active Test |
|---|---|
| B2795 | Different Serial Number |
If the transponder key ECU assembly or key is replaced, refer to Service Bulletin.
After repair, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".
Clear the DTCs.
Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>IMMOBILISER SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| NEXT |
NEXT
Insert and remove each registered key one at a time, and check for DTCs each time.
Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>IMMOBILISER SYSTEM>DTC CHECK / CLEAR
Before checking for DTCs, perform the "DTC Output Confirmation Operation" procedure.
If DTC B2795 is stored, check for DTCs with the next key after clearing the DTCs.
DTC B2795 is not output.
| Result | Proceed to |
|---|---|
| B2795 is not output | A |
| B2795 is output for all of the keys | B |
| B2795 is output for any of the keys | C |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
C
Check that the ignition switch can be turned to ON using the key for which the DTC was stored.
Ignition switch can be turned to ON using the key (for which the DTC was stored).
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Clear the DTCs.
Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>IMMOBILISER SYSTEM>DTC CHECK / CLEAR
Reregister the key ID code with the transponder key ECU assembly.
Refer to Service Bulletin.
Registration procedure can be completed.
| Proceed to |
|---|
| OK |
| NG |
OK
NG