Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE MASTER CYLINDER (w/o ABS) › from 2017.09
RM25T0E _54 Brake _029916 BRAKE SYSTEM (OTHER) _0138393 BRAKE MASTER CYLINDER(w/o ABS) A

BRAKE SYSTEM (OTHER)  BRAKE MASTER CYLINDER(w/o ABS)  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

Make sure to release the vacuum from the brake booster before removing the master cylinder from the brake booster.


PROCEDURE

Hide 1.DRAIN BRAKE FLUID

NOTICE:

Wash off brake fluid immediately if it comes in contact with any painted surface.


Hide 2.DISCONNECT BRAKE FLUID LEVEL WARNING SWITCH CONNECTOR

a.

Disconnect the brake fluid level warning switch connector.

C382377C01
0.094,0.052 0.406,0.208 0.313,0.156 10 false *A 3.802,0.052 4.115,0.208 0.313,0.156 10 false *B
*A for LHD *B for RHD



Hide 31434 3.DISCONNECT CLUTCH RESERVOIR TUBE

a.
C382378

Slide the clip and disconnect the clutch reservoir tube from the master cylinder reservoir.


Hide 47311 4.DISCONNECT FRONT NO. 1 BRAKE TUBE

a.

Using a union nut wrench, disconnect the front No. 1 brake tube from the brake master cylinder.

C382379C01
0.188,0.104 0.5,0.26 0.313,0.156 10 false *A 3.448,0.063 3.76,0.219 0.313,0.156 10 false *B
*A for LHD *B for RHD



Hide 47322 5.DISCONNECT REAR NO. 2 BRAKE TUBE

a.

Using a union nut wrench, disconnect the front No. 2 brake tube from the brake master cylinder.

C382380C01
0.406,0.167 0.719,0.323 0.313,0.156 10 false *A 3.521,0.146 3.833,0.302 0.313,0.156 10 false *B
*A for LHD *B for RHD



Hide 47201 6.REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY

a.

for 1GR-FE:

i.
C382381C01
0.333,0.229 0.646,0.385 0.313,0.156 10 false *A 0.281,2.521 0.594,2.677 0.313,0.156 10 false *B
*A for LHD
*B for RHD


Remove the 2 nuts.


ii.

Pull out brake master cylinder from the brake booster.

NOTICE:

Make sure foreign matter does not attach to the master cylinder piston. If foreign matter attaches, clean it off with a cloth. Then apply lithium soap base glycol grease to the entire outer circumference contact surface area of the piston.



iii.

Remove the brake master cylinder gasket from the brake master cylinder.



b.
C382382C01
0.448,0.24 0.76,0.396 0.313,0.156 10 false *A 0.417,2.469 0.729,2.625 0.313,0.156 10 false *B
*A for LHD
*B for RHD


for 1HZ:

i.

Remove the 2 nuts.


ii.

Pull out brake master cylinder from the brake booster.

NOTICE:

Make sure foreign matter does not attach to the master cylinder piston. If foreign matter attaches, clean it off with a cloth. Then apply lithium soap base glycol grease to the entire outer circumference contact surface area of the piston.



iii.

Remove the brake master cylinder gasket from the brake master cylinder.