Home › Engine / Hybrid System › 1VD-FTV (ENGINE CONTROL) › ECD SYSTEM (w/o EGR System) › from 2019.09
RM25T0E _51 Engine / Hybrid System _029760 1VD-FTV ENGINE CONTROL _0309414 ECD SYSTEM(w/o EGR System) D

1VD-FTV ENGINE CONTROL  ECD SYSTEM(w/o EGR System)  CHECK MODE PROCEDURE  


NOTICE:

All the stored DTCs and freeze frame data are erased if: 1) the ECM is changed from normal mode to check mode or vice versa; or 2) the ignition switch is turned from ON to ACC or off while in check mode. Before changing modes, always check and make a note of any DTCs and freeze frame data.


HINT:

GTS only:

Compared to the normal mode, check mode is more sensitive to malfunctions. Therefore, check mode can detect the malfunctions that cannot be detected by normal mode.


CHECK MODE PROCEDURE (Using GTS)


a.

Check and ensure the following conditions:

i.

Battery positive voltage 11 V or higher.


ii.

Transmission in the neutral position.


iii.

A/C switched OFF.



b.

Turn the ignition switch off.


c.

Connect the GTS to the DLC3.


d.

Turn the ignition switch to ON.


e.

Turn the GTS on.


f.

Enter the following menus: Powertrain / Engine and ECT / Utility / Check Mode.

Powertrain > Engine and ECT > Utility
Tester Display
Check Mode
50005 61 1

g.

Switch the ECM from normal mode to check mode.


h.
A076900E04
2.042,0.417 2.948,0.646 0.906,0.229 10 0.13 seconds 1.917,1.833 2.823,2.063 0.906,0.229 10 0.13 seconds 0.135,0.76 0.427,0.958 0.292,0.198 10 ON 0.135,1.385 0.427,1.583 0.292,0.198 10 OFF

Make sure the MIL flashes as shown in the illustration.


i.

Start the engine.


j.

Make sure the MIL turns OFF.


k.

Simulate the conditions of the malfunction described by the customer.


l.

Check DTCs and freeze frame data using the GTS.


m.

After checking the DTC, inspect the applicable circuit.