Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1. PRECAUTION
Be sure to read precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
45187 3.REMOVE LOWER NO. 3 STEERING WHEEL COVER
|
Protective Tape |
Apply protective tape as shown in the illustration.
Using a screwdriver, detach the claw and guide to remove the lower No. 3 steering wheel cover.
Tape the screwdriver tip before use.
45186 4.REMOVE LOWER NO. 2 STEERING WHEEL COVER (w/o Cruise Control System)
|
Protective Tape |
Apply protective tape as shown in the illustration.
Using a screwdriver, detach the claw and guide to remove the lower No. 2 steering wheel cover.
Tape the screwdriver tip before use.
45186 5.REMOVE LOWER NO. 2 STEERING WHEEL COVER (w/ Cruise Control System)
|
Protective Tape |
Apply protective tape as shown in the illustration.
Using a screwdriver, detach the claw and guide to remove the lower No. 2 steering wheel cover.
Tape the screwdriver tip before use.
45130 6.REMOVE STEERING PAD
When storing the steering pad, keep the airbag deployment side facing upward.
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
Using a T30 "TORX" socket wrench, loosen the 2 "TORX" screws until the groove along the screw circumference catches on the screw case.
| *a | Connector Lock |
|
Protective Tape |
Tilt the steering pad toward the seat and support it with one hand.
Disconnect the horn connector.
Using a screwdriver, release the connector lock and disconnect the airbag connector.
When handling the airbag connector, take care not to damage the airbag wire harness.
Tape the screwdriver tip before use.