84970 1.INSPECT COMBINATION SWITCH ASSEMBLY (IDLE UP SWITCH)
| *a | Component without harness connected (Combination Switch Assembly (Idle Up Switch)) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 9 - 10 | Idle up switch ON | Below 1 Ω |
| Idle up switch OFF | 10 kΩ or higher |
Apply battery voltage to the connector and check the LED illumination.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → 5 (ILL+) Battery negative (-) → 7 (ILL-) |
LED illuminates |
If the result is not as specified, there may be a malfunction in the combination switch assembly (idle up switch).