Home › Engine / Hybrid System › 1VD-FTV (EMISSION CONTROL) › DPF SWITCH (for DPF) › from 2021.07
RM25T0E _51 Engine / Hybrid System _029525 1VD-FTV EMISSION CONTROL _0290818 DPF SWITCH(for DPF) G

1VD-FTV EMISSION CONTROL  DPF SWITCH(for DPF)  INSPECTION  


PROCEDURE

Hide 84270K 1.INSPECT COMBINATION SWITCH ASSEMBLY (DPF SWITCH ASSEMBLY)

a.
A489083C01
2.208,1.115 2.615,0.531 2.615,0.531 2.75,0.531 true 0.729,0.406 0.854,0.406 0.854,0.406 1.292,1.083 true 1.938,1.25 2.229,0.25 2.229,0.25 2.365,0.25 true 1.375,0.365 1.5,0.365 1.5,0.365 1.781,1.104 true 0.073,0.094 0.385,0.25 0.313,0.156 10 false *a 0.417,0.333 0.823,0.531 0.406,0.198 10 false ILL+ 2.448,0.177 2.854,0.375 0.406,0.198 10 false ILL- 2.833,0.469 3.083,0.667 0.25,0.198 10 false B 1.219,0.281 1.438,0.49 0.219,0.208 10 false E
*a Component without harness connected
(Combination Switch Assembly (DPF Switch Assembly))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
1 (B) - 3 (E) Not Pushed 10 kΩ or higher
Pushed Below 1 Ω


If the result is not as specified, replace the combination switch assembly (DPF switch assembly).


b.

Apply battery voltage between the terminals of the switch, and check the illumination condition of the combination switch assembly (DPF switch assembly).

OK:
Measurement Condition Specified Condition
Battery positive (+) → 5 (ILL+)
Battery negative (-) → 7 (ILL-)
Illuminates


If the result is not as specified, replace the combination switch assembly (DPF switch assembly).