CHECK COMBINATION METER ASSEMBLY
Disconnect the L25 combination meter assembly connector.
Measure the resistance and voltage according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| L25-15 (ES) - Body ground | BR - Body ground | Ground | Always | Below 1 Ω |
| L25-26 (B) - Body ground | R - Body ground | Battery power supply | Always | 11 to 14 V |
| L25-28 (B) - Body ground | B-Y - Body ground | IG power supply | Ignition switch ON | 11 to 14 V |
| Ignition switch off | Below 1 V |
Reconnect the L25 combination meter assembly connector.
Measure the voltage according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| L25-6 (DOOR) - Body ground | B-W - Body ground | Driver side door input signal | Driver side door closed | Below 1 V |
| Driver side door open | 11 to 14 V | |||
| L26-18 (SW) - Body ground | B-R - Body ground | Unlock warning switch input signal | No key in ignition key cylinder | 11 to 14 V |
| Ignition switch off, key in ignition key cylinder | Below 1 V |