Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1. PRECAUTION
Be sure to read precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
45186 3.REMOVE LOWER NO. 2 STEERING WHEEL COVER
|
Protective Tape |
Apply protective tape as shown in the illustration.
Using a screwdriver, insert the screwdriver into the cutout of the lower No. 2 steering wheel cover and detach the claw and guide to remove the lower No. 2 steering wheel cover.
Tape the screwdriver tip before use.
45187 4.REMOVE LOWER NO. 3 STEERING WHEEL COVER
|
Protective Tape |
Apply protective tape as shown in the illustration.
Using a screwdriver, insert the screwdriver into the cutout of the lower No. 3 steering wheel cover and detach the claw and guide to remove the lower No. 3 steering wheel cover.
Tape the screwdriver tip before use.
45130 5.REMOVE STEERING PAD
When storing the steering pad, keep the airbag deployment side facing upward.
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
|
Release in this Direction |
Using a screwdriver, push in the torsion springs to detach the pins as shown in the illustration.
Do not drop the steering pad.
When disconnecting the steering pad, do not pull the airbag wire harness.
Insert the screwdriver into the installation areas of the lower No. 2 steering wheel cover and lowerNo. 3 steering wheel cover.
| *a | Connector Lock |
|
Protective Tape |
Tilt the steering pad toward the seat and support it with one hand.
Using a screwdriver, release the connector lock and disconnect the airbag connector.
When handling the airbag connector, take care not to damage the airbag wire harness.
Tape the screwdriver tip before use.
Disconnect the horn connector.