Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT PASSENGER AIRBAG ASSEMBLY › from 2022.09
RM25T0E _58 Vehicle Interior _029929 SUPPLEMENTAL RESTRAINT SYSTEMS _0138000 FRONT PASSENGER AIRBAG ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  FRONT PASSENGER AIRBAG ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


Hide 55550 3.REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

Hide 55433B 4.REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL

a.
B388007

Detach the 3 claws as shown in the illustration.


b.

Pull the lower No. 2 instrument panel finish panel to detach the 2 guides and remove it.


Hide 73970A 5.REMOVE INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY

CAUTION:

When storing the instrument panel passenger airbag assembly, keep the airbag deployment side facing upward.


a.
B374342C01
0.74,2.563 0.833,2.281 0.833,2.281 1.073,2.281 true 1.135,2.167 1.448,2.323 0.313,0.156 10 false *1
*1 Slider


Slide the slider to release the lock, and then disconnect the airbag connector.

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.



b.
B234323

Remove the 2 bolts.


c.
B374344

Detach the 14 claws and 2 guides and remove the instrument panel passenger airbag assembly.


d.
B374371

Detach the wire harness clamp.


Hide 82143 6.REMOVE NO. 3 INSTRUMENT PANEL WIRE

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.


a.
B374345C01
2.698,1.438 2.844,1.167 2.844,1.167 3.01,1.167 true 3.073,1.063 3.313,1.26 0.24,0.198 10 false *1
*1 Connector Lock
V100155

Protective Tape


Using a screwdriver, release the connector lock and disconnect the airbag connector.

HINT:

Tape the screwdriver tip before use.



b.

Detach the wire harness clamp and remove the No. 3 instrument panel wire.