Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1. PRECAUTION
Be sure to read precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
53111 3.REMOVE RADIATOR GRILLE
for Standard:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER (for Standard)>REMOVAL
for Step Type:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER (for Step Type)>REMOVAL
4.REMOVE HEADLIGHT ASSEMBLY LH (w/ Curtain Shield Airbag)
89174A 5.REMOVE FRONT AIRBAG SENSOR LH
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
Disconnect the airbag connector.
When disconnecting any airbag connector, take care not to damage the airbag wire harness.
Push down the housing lock and slide the CPA.(At this time, the connector cannot be disconnected yet.)
| *a | Housing Lock | *b | CPA |
| *c | CPA Upper Part | - | - |
Push the housing lock again and disconnect the connector.
Do not push down the upper part of the CPA shown in the illustration when disconnecting the airbag connector.
After disconnecting the connector, check that the position of the housing lock is correct as shown in the illustration.
| *a | Incorrect | *b | Correct |
w/o Curtain Shield Airbag
Remove the nut.
Loosen the nut while holding the front airbag sensor LH because the front airbag sensor LH guide is easily damaged.
Detach the guide and remove the front airbag sensor LH.
If the front airbag sensor LH has been dropped, replace it with a new one.
w/ Curtain Shield Airbag
Remove the bolt.
Loosen the bolt while holding the front airbag sensor LH because the front airbag sensor LH guide is easily damaged.
Detach the guide and remove the front airbag sensor LH.
If the front airbag sensor LH has been dropped, replace it with a new one.