Home › Vehicle Interior › SEAT BELT › FRONT SEAT OUTER BELT ASSEMBLY (for Single Cab) › from 2022.09
RM25T0E _58 Vehicle Interior _029931 SEAT BELT _0142807 FRONT SEAT OUTER BELT ASSEMBLY(for Single Cab) A

SEAT BELT  FRONT SEAT OUTER BELT ASSEMBLY(for Single Cab)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION (w/ Pretensioner and Force Limiter)

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Pretensioner and Force Limiter)

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


Hide 73174 3.REMOVE FRONT SEAT BELT HOLE COVER LH (w/o Pretensioner and Force Limiter)

Hide 67914 4.REMOVE FRONT DOOR SCUFF PLATE LH (w/ Pretensioner and Force Limiter)

Hide 62316C 5.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH (w/ Pretensioner and Force Limiter)

HINT:

Disconnect the rear side of the front door opening trim weatherstrip LH so that the center pillar garnish LH can be removed.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (for Single Cab)>REMOVAL


Hide 62412 6.REMOVE CENTER PILLAR GARNISH LH (w/ Pretensioner and Force Limiter)

Hide 73024 7.REMOVE FRONT SHOULDER BELT ANCHOR PLATE SUB-ASSEMBLY LH (w/ Pretensioner and Force Limiter)

a.
B452003

Detach the 6 guides and remove the front shoulder belt anchor plate sub-assembly LH.


Hide 73220 8.REMOVE FRONT SEAT OUTER BELT ASSEMBLY LH

a.

w/o Pretensioner and Force Limiter:

i.
B234356

Loosen the bolt and disconnect the floor anchor of the front seat outer belt assembly LH.


ii.
B388293

Using moulding remover D, detach the 2 claws and open the front seat outer belt shoulder anchor cover.


iii.
B233859

Loosen the bolt and disconnect the shoulder anchor of the front seat outer belt assembly LH.


iv.
B386634

Remove the 2 bolts.


v.

Detach the guide and remove the front seat outer belt assembly LH.



b.
B456589

w/ Pretensioner and Force Limiter:

i.

Remove the nut and disconnect the shoulder anchor of the front seat outer belt assembly LH.


ii.
B456588C01
0.323,0.833 0.667,0.667 true 0.406,0.281 1.781,0.125 true 0.146,0.771 0.406,0.969 0.26,0.198 10 false *a 1.833,0.01 2.094,0.208 0.26,0.198 10 false *b
*a Locking Button
*b Protective Tape


Using a screwdriver, pull out the locking button as shown in the illustration to release the lock and disconnect the pretensioner connector as shown in the illustration.

HINT:

Tape the screwdriver tip before use.



iii.

Remove the 2 bolts.


iv.

Detach the 2 guides and remove the front seat outer belt assembly LH.



Hide 73200A 9.REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY (w/ Pretensioner and Force Limiter)

a.
B456590

Remove the 2 bolts.


b.

Detach the guide and remove the front shoulder belt anchor adjuster assembly.