Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM (w/ Pre-collision System) › from 2022.09
RM25T0E _54 Brake _029873 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0548732 VEHICLE STABILITY CONTROL SYSTEM(w/ Pre-collision System) D

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM(w/ Pre-collision System)  CHECK FOR INTERMITTENT PROBLEMS  


CHECK FOR INTERMITTENT PROBLEMS


HINT:

A momentary interruption (open circuit) in the connectors and/or wire harness between the sensors and ECUs can be detected using the Data List function of the GTS.


a.

Follow the directions on the GTS to display the Data List and select areas where momentary interruption should be monitored.

HINT:
·

A momentary interruption (open circuit) cannot be detected for 3 seconds after the ignition switch is turned to ON (initial check).

·

If Under intermittent remains displayed for one of the items on the GTS, check for continuity between the ECU and the item for which Under intermittent is displayed.

·

If a momentary interruption occurs and Under intermittent is displayed on the GTS, Under intermittent will remain displayed on the GTS for 1 second after the circuit returns to normal.



Chassis > Brake > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
FR Speed Open Front speed sensor RH open detection Under intermittent or Normal Under intermittent: Momentary interruption detected
Normal: Momentary interruption not detected
·

After a momentary interruption occurs, if there is no momentary interruption for 1 second, it switches from "Under intermittent" to "Normal".

·

Related DTC: C050614, C05061F


FL Speed Open Front speed sensor LH open detection Under intermittent or Normal Under intermittent: Momentary interruption detected
Normal: Momentary interruption not detected
·

After a momentary interruption occurs, if there is no momentary interruption for 1 second, it switches from "Under intermittent" to "Normal".

·

Related DTC: C050014, C05001F


RR Speed Open Rear speed sensor RH open detection Under intermittent or Normal Under intermittent: Momentary interruption detected
Normal: Momentary interruption not detected
·

After a momentary interruption occurs, if there is no momentary interruption for 1 second, it switches from "Under intermittent" to "Normal".

·

Related DTC: C051214, C05121F


RL Speed Open Rear speed sensor LH open detection Under intermittent or Normal Under intermittent: Momentary interruption detected
Normal: Momentary interruption not detected
·

After a momentary interruption occurs, if there is no momentary interruption for 1 second, it switches from "Under intermittent" to "Normal".

·

Related DTC: C050C14, C050C1F


EFI Communication Open ECM communication open detection Under intermittent or Normal Under intermittent: Momentary interruption detected
Normal: Momentary interruption not detected
·

After a momentary interruption occurs, if there is no momentary interruption for 1 second, it switches from "Under intermittent" to "Normal".

·

Related Vehicle Control History (RoB): X2079

·

Related DTC: U010087


Yaw Rate Open Yaw rate sensor open detection Under intermittent or Normal Under intermittent: Momentary interruption detected
Normal: Momentary interruption not detected
·

After a momentary interruption occurs, if there is no momentary interruption for 1 second, it switches from "Under intermittent" to "Normal".

·

Related DTC: U012587


Deceleration Open Acceleration sensor open detection Under intermittent or Normal Under intermittent: Momentary interruption detected
Normal: Momentary interruption not detected
·

After a momentary interruption occurs, if there is no momentary interruption for 1 second, it switches from "Under intermittent" to "Normal".

·

Related DTC: U012587


Steering Open Steering sensor open detection Under intermittent or Normal Under intermittent: Momentary interruption detected
Normal: Momentary interruption not detected
·

After a momentary interruption occurs, if there is no momentary interruption for 1 second, it switches from "Under intermittent" to "Normal".

·

Related DTC: U012687


Master Cylinder Open Master cylinder pressure sensor open detection Under intermittent or Normal Under intermittent: Momentary interruption detected
Normal: Momentary interruption not detected
·

After a momentary interruption occurs, if there is no momentary interruption for 1 second, it switches from "Under intermittent" to "Normal".

·

Related DTC: C054031


FR Speed Sensor Voltage Open Front speed sensor RH voltage open detection Under intermittent or Normal Under intermittent: Momentary interruption detected
Normal: Momentary interruption not detected
·

After a momentary interruption occurs, if there is no momentary interruption for 1 second, it switches from "Under intermittent" to "Normal".

·

Related DTC: C050614


FL Speed Sensor Voltage Open Front speed sensor LH voltage open detection Under intermittent or Normal Under intermittent: Momentary interruption detected
Normal: Momentary interruption not detected
·

After a momentary interruption occurs, if there is no momentary interruption for 1 second, it switches from "Under intermittent" to "Normal".

·

Related DTC: C050014


RR Speed Sensor Voltage Open Rear speed sensor RH voltage open detection Under intermittent or Normal Under intermittent: Momentary interruption detected
Normal: Momentary interruption not detected
·

After a momentary interruption occurs, if there is no momentary interruption for 1 second, it switches from "Under intermittent" to "Normal".

·

Related DTC: C051214


RL Speed Sensor Voltage Open Rear speed sensor LH voltage open detection Under intermittent or Normal Under intermittent: Momentary interruption detected
Normal: Momentary interruption not detected
·

After a momentary interruption occurs, if there is no momentary interruption for 1 second, it switches from "Under intermittent" to "Normal".

·

Related DTC: C050C14


M/C Pressure Sensor Noise Master cylinder pressure sensor noise detection Under intermittent or Normal Under intermittent: Noise detected
Normal: Noise not detected
·

After noise occurs, if there is no noise for 5 seconds, it switches from "Under intermittent" to "Normal".

·

Related DTC: C054049


Yaw Rate Sensor Voltage Open Yaw rate sensor voltage open detection Under intermittent or Normal Under intermittent: Momentary interruption detected
Normal: Momentary interruption not detected
·

After a momentary interruption occurs, if there is no momentary interruption for 1 second, it switches from "Under intermittent" to "Normal".

·

Related DTC: C14D71C


EFI Communication Invalid ECM communication invalid detection Under intermittent or Normal Under intermittent: ECM communication invalid state detected
Normal: ECM communication invalid state not detected
·

After ECM communication invalid state occurs, if there no further invalid state occurs, it switches from "Under intermittent" to "Normal".

·

Related Vehicle Control History (RoB): X2079

·

Related DTC: U010087


Master Cylinder Pressure Sensor Power Supply Open Master cylinder pressure sensor power supply voltage status Under intermittent or Normal Under intermittent: Momentary interruption detected
Normal: Momentary interruption not detected
·

After a momentary interruption occurs, if there is no momentary interruption for 1 second, it switches from "Under intermittent" to "Normal".

·

Related DTC: C054049


Solenoid Power Supply Open Solenoid power supply voltage status Under intermittent or Normal Under intermittent: Momentary interruption detected
Normal: Momentary interruption not detected
·

After a momentary interruption occurs, if there is no momentary interruption for 1 second, it switches from "Under intermittent" to "Normal".

·

Related DTC: C143A7F


Motor Power Supply Open Motor power supply voltage status Under intermittent or Normal Under intermittent: Momentary interruption detected
Normal: Momentary interruption not detected
·

After a momentary interruption occurs, if there is no momentary interruption for 1 second, it switches from "Under intermittent" to "Normal".

·

Related DTC: C052F14


Stop Switch Open Momentary interruption (open circuit) status in wire harness between skid control ECU (brake actuator assembly) and stop light switch assembly status Under intermittent or Normal Under intermittent: Momentary interruption detected
Normal: Momentary interruption not detected
·

After a momentary interruption occurs, if there is no momentary interruption for 1 second, it switches from "Under intermittent" to "Normal".

·

Related DTC: C054017, P057113



b.

While observing the screen, gently jiggle the connector or wire harness between the ECU and sensors, or between ECUs.

OK:

Normal is displayed.


HINT:

If the display changes, this indicates that there has been a momentary interruption (open circuit) in the connector and/or wire harness. In this case, repair or replace the connectors and/or wire harnesses as one of them is faulty.



c.

While observing the screen, gently jiggle the connector or wire harness between the ECU and each sensors, or between ECUs.

OK:

Normal is displayed.


HINT:
·

If a momentary interruption occurs and Under intermittent is displayed on the GTS, Under intermittent will remain displayed on the GTS for 1 second after the circuit returns to normal.

C399553E20
0.073,0.073 3.292,0.354 3.219,0.281 10 false Reference: GTS display at momentary interruption 0.208,0.875 1.823,1.292 1.615,0.417 10 false Wire Harness condition 0.948,1.927 1.792,2.26 0.844,0.333 10 false Line Graph 2.615,1.375 3.396,1.688 0.781,0.313 10 false 1 second 4.219,1.354 4.938,1.542 0.719,0.188 10 false 2 seconds 4.083,0.313 5.417,0.677 1.333,0.365 10 false 1.5 seconds 2.438,0.313 3.438,0.552 1,0.24 10 false 0.5 seconds 5.656,1.76 6.927,2.073 1.271,0.313 10 false Under intermittent 5.667,2.135 6.417,2.469 0.75,0.333 10 false Normal 5.625,0.708 7.104,1 1.479,0.292 10 false Momentary interruption 5.635,1.073 6.385,1.396 0.75,0.323 10 false Normal

·

If the display changes, this indicates that there has been a momentary interruption (open circuit) in the connector and/or wire harness. In this case, repair or replace the connectors and/or wire harnesses as one of them is faulty.