Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
3.PLACE FRONT WHEELS FACING STRAIGHT AHEAD
45100 4.REMOVE STEERING WHEEL ASSEMBLY
45287 5.REMOVE LOWER STEERING COLUMN COVER
45286B 6.REMOVE UPPER STEERING COLUMN COVER
84306 7.REMOVE SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY
Do not replace the spiral with sensor cable sub-assembly with the battery connected and the ignition switch ON.
Do not rotate the spiral with sensor cable sub-assembly with the battery connected and the ignition switch ON.
When rotating the spiral with sensor cable sub-assembly to check the operation of the sub-assembly (checking for abnormal noise, checking the Data List, etc.), make sure to perform the inspection with the steering wheel assembly installed.
| *a | Slider |
Slide the airbag connector slider as shown in the illustration and disconnect the airbag connector from the spiral with cable sensor sub-assembly.
Disconnect each connector from the spiral with sensor cable sub-assembly.
Detach the 3 claws and remove the spiral with sensor cable sub-assembly.