Home › Engine / Hybrid System › 1GR-FE (ENGINE CONTROL) › SFI SYSTEM › from 2021.12
RM25T0E _51 Engine / Hybrid System _029758 1GR-FE ENGINE CONTROL _0135343 SFI SYSTEM D

1GR-FE ENGINE CONTROL  SFI SYSTEM  FREEZE FRAME DATA  


DESCRIPTION


A103809E88
2.354,0.135 3.229,0.302 0.875,0.167 10 DTC stored 1.271,1.031 2.052,1.208 0.781,0.177 10 0.5 seconds 0.323,1.031 1.104,1.229 0.781,0.198 10 0.5 seconds 0.354,2.792 2.688,2.948 2.333,0.156 10 Freeze frame data which can be read 2.25,1.031 3.031,1.229 0.781,0.198 10 0.5 seconds

Freeze frame data records the engine conditions (fuel system, calculated load, engine coolant temperature, fuel trim, engine speed, vehicle speed, etc.) when a malfunction is detected. When troubleshooting, it can help determine if the vehicle was moving or stationary, the engine was warmed up or not, the air fuel ratio was lean or rich, and other data from the time the malfunction occurred.

HINT:

If it is impossible to duplicate the problem even though a DTC is output, confirm the freeze frame data.


The ECM records engine conditions in the form of freeze frame data every 0.5 seconds. Using the GTS, 5 separate sets of freeze frame data can be checked.

·

3 data sets before the DTC was stored.

·

1 data set when the DTC was stored.

·

1 data set after the DTC was stored.


These data sets can be used to simulate the condition of the vehicle around the time of the occurrence of the malfunction. The data may assist in identifying the cause of the malfunction, and in judging whether it was temporary or not.


LIST OF FREEZE FRAME DATA


Powertrain > Engine and ECT
Tester Display
Vehicle Speed
Key Cycle
Elapsed Time
Engine Speed
Calculate Load
Vehicle Load
MAF
Atmosphere Pressure
Coolant Temp
Intake Air
Ambient Temperature
Engine Run Time
Initial Engine Coolant Temp
Initial Intake Air Temp
Battery Voltage
Accel Sens. No.1 Volt %
Accel Sens. No.2 Volt %
Throttle Sensor Volt %
Throttl Sensor #2 Volt %
Throttle Sensor Position
Throttle Motor DUTY
Throttle Position
ISC Flow
ISC Position
ISC Feedback Value
ISC Learning Value
Electric Load Feedback Val
Air Conditioner FB Val
PS Feedback Val
Neutral Control
N Range Status
Eng Stall Control FB Flow
Deposit Loss Flow
Injector (Port)
Injection Volum (Cylinder1)
Fuel Pump Speed Control
Fuel Pump/Speed Status
EVAP (Purge) VSV
Evap Purge Flow
Purge Density Learn Value
EVAP Purge VSV
Target Air-Fuel Ratio
AF Lambda B1S1
AF Lambda B2S1
AFS Voltage B1S1
AFS Voltage B2S1
AFS Current B1S1
AFS Current B2S1
O2S B1S2
O2S B2S2
Short FT #1
Short FT B1S2
Long FT #1
Long FT B1S2
Total FT #1
Short FT #2
Short FT B2S2
Long FT #2
Long FT B2S2
Total FT #2
Fuel System Status #1
Fuel System Status #2
IGN Advance
Knock Feedback Value
Knock Correct Learn Value
ACIS VSV
VVT Control Status #1
VVT Control Status #2
VVT Advance Fail
Catalyst Temp B1S1
Catalyst Temp B2S1
Catalyst Temp B1S2
Catalyst Temp B2S2
Starter Signal
Power Steering Signal
Power Steer. Sig. Record
Stop Light Switch
A/C Signal
Closed Throttle Position SW
Fuel Cut Condition
Immobiliser Communication
Electrical Load Signal
Time after DTC Cleared
Distance from DTC Cleared
Warmup Cycle Cleared DTC
TC and TE1
Ignition Trig. Count
Cylinder #1 Misfire Count
Cylinder #2 Misfire Count
Cylinder #3 Misfire Count
Cylinder #4 Misfire Count
Cylinder #5 Misfire Count
Cylinder #6 Misfire Count
All Cylinders Misfire Count
Misfire RPM
Misfire Load
Misfire Margin
Catalyst OT MF F/C
Cat OT MF F/C History
Cat OT MF F/C Cylinder#1
Cat OT MF F/C Cylinder#2
Cat OT MF F/C Cylinder#3
Cat OT MF F/C Cylinder#4
Cat OT MF F/C Cylinder#5
Cat OT MF F/C Cylinder#6
Previous Trip Coolant Temp
Previous Trip Intake Temp
Fuel Cut Elps Time
ACT VSV
Idle Fuel Cut
FC TAU
Immobiliser Fuel Cut