Home › Vehicle Interior › PRE-COLLISION › PRE-COLLISION SYSTEM CANCEL SWITCH › from 2022.09
RM25T0E _58 Vehicle Interior _128087 PRE-COLLISION _0558233 PRE-COLLISION SYSTEM CANCEL SWITCH G

PRE-COLLISION  PRE-COLLISION SYSTEM CANCEL SWITCH  INSPECTION  


PROCEDURE

Hide 84970 1.INSPECT COMBINATION SWITCH ASSEMBLY (PCS SWITCH ASSEMBLY)

a.
A489083C02
1.948,1.385 2.146,1.885 2.146,1.885 2.281,1.885 true 0.729,0.406 0.854,0.406 0.854,0.406 1.292,1.083 true 1.031,1.792 1.229,1.792 1.229,1.792 1.521,1.396 true 1.344,2.042 1.469,2.042 1.469,2.042 1.719,1.406 true 0.073,0.094 0.385,0.25 0.313,0.156 10 false *a 0.417,0.333 0.823,0.531 0.406,0.198 10 false ILL+ 2.333,1.792 2.74,1.99 0.406,0.198 10 false ILL- 1.031,1.958 1.51,2.156 0.479,0.198 10 false ECU 0.896,1.708 1.115,1.917 0.219,0.208 10 false E
*a Component without harness connected
(Combination Switch Assembly (PCS Switch Assembly))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
8 (ECU) - 9 (E) Not Pushed 10 kΩ or higher
Pushed Below 1 Ω


If the result is not as specified, replace the combination switch assembly (PCS switch assembly).


b.

Apply battery voltage between the terminals of the switch, and check the illumination condition of the combination switch assembly (PCS switch assembly).

OK:
Measurement Condition Specified Condition
Battery positive (+) → 5 (ILL+)
Battery negative (-) → 7 (ILL-)
Illuminates


If the result is not as specified, replace the combination switch assembly (PCS switch assembly).