1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
19871 3.REMOVE NO. 1 GLOW PLUG CONNECTOR
Remove the 6 glow plug screw grommets.
Remove the 6 nuts, No. 1 glow plug connector and disconnect the wire harness.
19850 4.REMOVE GLOW PLUG ASSEMBLY
Using a 12 mm deep socket wrench, remove the 6 glow plug assemblies.
Do not remove the glow plug assembly before warming up the engine.