Home › Engine / Hybrid System › 1HZ (STARTING) › GLOW PLUG › from 2022.09
RM25T0E _51 Engine / Hybrid System _029899 1HZ STARTING _0136994 GLOW PLUG A

1HZ STARTING  GLOW PLUG  INSTALLATION  


PROCEDURE

Hide 19850 1.INSTALL GLOW PLUG ASSEMBLY

a.

Clean the glow plug assembly installation holes in the cylinder head.


b.

Using a 12 mm deep socket wrench, install the 6 glow plug assemblies.

Torque:
12.7 N*m (130 kgf*cm, 9 ft.*lbf)


Hide 19871 2.INSTALL NO. 1 GLOW PLUG CONNECTOR

a.

Install the No. 1 glow plug connector and wire harness with the 6 nuts.

Torque:
2.2 N*m (22 kgf*cm, 19 in.*lbf)


b.

Install the 6 glow plug screw grommets.

HINT:

Push the glow plug screw grommet into the threaded portion of the glow plug assembly by hand, and then turn it clockwise.



Hide 3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 4. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL

HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART