Home › Vehicle Interior › PRE-COLLISION › FRONT CAMERA SYSTEM › from 2022.09
RM25T0E _58 Vehicle Interior _128087 PRE-COLLISION _0564254 FRONT CAMERA SYSTEM C

PRE-COLLISION  FRONT CAMERA SYSTEM  U010087  Lost Communication with ECM/PCM "A" Missing Message  U012587  Lost Communication with Multi-axis Acceleration Sensor Module Missing Message  U012687  Lost Communication with Steering Angle Sensor Module Missing Message  U012987  Lost Communication with Brake System Control Module Missing Message  U015587  Lost Communication with Instrument Panel Cluster (IPC) Control Module Missing Message  


DESCRIPTION

When a malfunction is detected between various ECUs and sensors, these DTCs are stored.

DTC No. Detection Item DTC Detection Condition Trouble Area
U010087 Lost Communication with ECM/PCM "A" Missing Message 3 seconds after the ignition switch is turned to ON, while the vehicle is being driven at 1 km/h or 1 mph or more, a communication error between the ECM and the forward recognition camera is detected for 5 seconds or more. CAN communication system
U012587 Lost Communication with Multi-axis Acceleration Sensor Module Missing Message 3 seconds after the ignition switch is turned to ON, a communication error between the skid control ECU (brake actuator assembly) and the forward recognition camera is detected for 5 seconds or more. CAN communication system
U012687 Lost Communication with Steering Angle Sensor Module Missing Message 3 seconds after the ignition switch is turned to ON, a communication error between the steering angle sensor (spiral with sensor cable sub-assembly) and the forward recognition camera is detected for 5 seconds or more. CAN communication system
U012987 Lost Communication with Brake System Control Module Missing Message 3 seconds after the ignition switch is turned to ON, a communication error between the skid control ECU (brake actuator assembly) and the forward recognition camera is detected for 5 seconds or more. CAN communication system
U015587 Lost Communication with Instrument Panel Cluster (IPC) Control Module Missing Message 3 seconds after the ignition switch is turned to ON, a communication error between the combination meter assembly and the forward recognition camera is detected for 5 seconds or more. CAN communication system

PROCEDURE

1.CLEAR DTC
a.

Clear the DTCs.

Chassis > Front Recognition Camera > Clear DTCs
50002 430

Result:
Proceed to
NEXT



NEXT

2.CHECK FOR DTCs
2.CHECK FOR DTCs
a.

Make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.



b.

Check for DTCs.

Chassis > Front Recognition Camera > Trouble Codes
50001 430
Result:
Result Proceed to
CAN communication system DTC is not output A
CAN communication system DTC is output B




A

B