Home › Vehicle Interior › PRE-COLLISION › MILLIMETER WAVE RADAR SENSOR › from 2022.09
RM25T0E _58 Vehicle Interior _128087 PRE-COLLISION _0564253 MILLIMETER WAVE RADAR SENSOR A

PRE-COLLISION  MILLIMETER WAVE RADAR SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:

If the millimeter wave radar sensor assembly has been struck or dropped, replace the millimeter wave radar sensor assembly with a new one.


PROCEDURE

Hide 88211B 1.INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY

a.
B650256C02
2.583,1.448 2.844,1.646 0.26,0.198 10 true (1) 0.781,1.448 1.042,1.646 0.26,0.198 10 true (2) 1.771,0.177 2.031,0.365 0.26,0.188 10 true (3)
V100135

Bolt
V100136

Screw


Attach the guide.


b.

Temporarily install the millimeter wave radar sensor assembly with the 2 bolts and screw.


c.

Tighten the 2 bolts and screw in the order shown in the illustration.

Torque:
Bolt : 2.5 N*m (25 kgf*cm, 22 in.*lbf)


Hide 88211B 3.ADJUST MILLIMETER WAVE RADAR SENSOR ASSEMBLY

a.

When the millimeter wave radar sensor assembly is replaced with a new one, adjustment of the radar sensor beam axis must be performed.

HINT:

Millimeter wave radar sensor assembly learning can be performed by using either Target Adjustment (Triangle Target) or Target Adjustment (Flat Surface Target) or Driving Adjustment.