1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
3.DISCONNECT CABLE FROM POSITIVE BATTERY TERMINAL
74481 4.REMOVE BATTERY HOLD DOWN CLAMP
for Model Code #J79 Series:
Remove the bolt and loosen the 2 nuts.
Remove the bolt and loosen the nut.
Detach the hook of the battery hold down clamp from the front battery bracket, and then remove the battery hold down clamp.
28800 5.REMOVE BATTERY
28380A 6.REMOVE FUEL PUMP RESISTOR
Disconnect the fuel pump resistor connector from the fuel pump resistor.
Remove the bolt and fuel pump resistor.