ТОПЛИВНАЯ ФОРСУНКА > СНЯТИЕ

для подготовки Нажмите здесь



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

ПРИМЕЧАНИЕ:
  1. After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page Нажмите здесь).
  2. When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page Нажмите здесь).



2. REMOVE DIESEL THROTTLE BODY

  1. Remove the diesel throttle body (See page Нажмите здесь).



3. REMOVE INJECTION PIPE SET


    A00JY0JE03

  1. Using a union nut wrench, loosen the 8 union nuts of the 4 injection pipes.
    Text in Illustration 
    *1
    		Union Nut Wrench
    *a
    		for Injection Nozzle Side
    *b
    		for Injection Pump Side

  1. Remove the 2 nuts, 2 upper pipe clamps and 4 injection pipes with 2 lower pipe clamps.



4. REMOVE NO. 1 GLOW PLUG CONNECTOR


    A00JTSS

  1. Remove the nut, No. 2 glow plug resistor insulator and washer and disconnect the wire harness.

  1. Remove the 4 screw grommets and 4 nuts.

  1. Remove the No. 1 glow plug connector and No. 1 glow plug resistor insulator.



5. REMOVE NOZZLE LEAKAGE PIPE ASSEMBLY


    A00JV8C

  1. Disconnect the fuel hose from the leakage pipe.

  1. Remove the 4 nuts, leakage pipe and 4 ring packing washers.



6. REMOVE NOZZLE HOLDER AND NOZZLE SET


    A00JX41E01

  1. Using SST, remove the 4 injection nozzles, 4 injection nozzle seats and 4 injection nozzle seat gaskets.

    SST
    09268-64010   (09268-64020)