ПРИВОДНОЙ РЕМЕНЬ > СНЯТИЕ

для подготовки Нажмите здесь



1. REMOVE FRONT BUMPER COVER LOWER

  1. Remove the clip, 5 bolts and front bumper cover lower.



2. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

  1. Remove the 4 bolts.



    A00JXIF

  1. Unhook the engine under cover from the vehicle body as shown in the illustration.



3. REMOVE FRONT FENDER APRON SEAL RH

  1. Remove the 4 clips and fender apron seal.



4. REMOVE RESONATOR WITH AIR CLEANER CAP SUB-ASSEMBLY


    A0098PV

  1. Disconnect the sensor connector.

  1. Detach the wire harness clamp.

  1. Loosen the hose clamp and remove the resonator with air cleaner cap.



    A0099K2

  1. Detach the 4 hook clamps, and then remove the air cleaner cap and resonator with air cleaner cap.



5. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY


6. REMOVE AIR CLEANER CASE ASSEMBLY


    A00JYCZ

  1. Remove the 3 bolts and air cleaner case.



7. REMOVE VANE PUMP V BELT


    A009A8N

  1. Loosen bolt and nut, and remove the V belt.



8. REMOVE COOLER COMPRESSOR V BELT


    A009B8WE03

  1. Loosen nut and adjusting bolt, and remove the V belt.
    Text in Illustration 
    *1
    		Adjusting Bolt



9. REMOVE FAN AND GENERATOR V BELT


    A0099F1E03

  1. Loosen 2 bolts.

  1. Loosen adjusting bolt, and remove the V belt.
    Text in Illustration 
    *1
    		Adjusting Bolt