ЗАДНИЙ САЛЬНИК КОЛЕНЧАТОГО ВАЛА > СНЯТИЕ

для подготовки Нажмите здесь



1. REMOVE MANUAL TRANSMISSION ASSEMBLY

  1. Remove the manual transmission (See page Нажмите здесь).



2. REMOVE CLUTCH COVER ASSEMBLY


    A0098BWE01

  1. Place matchmarks on the clutch cover and flywheel.
    Text in Illustration 
    *a
    		Matchmark

  1. Loosen each set bolt one turn at a time until spring tension is released.

  1. Remove the 6 set bolts and pull off the clutch cover.

    ПРИМЕЧАНИЕ:
    Do not drop the clutch disc.



3. REMOVE CLUTCH DISC ASSEMBLY

ПРИМЕЧАНИЕ:
Keep the lining part of the clutch disc, the pressure plate and the surface of the flywheel away from oil and foreign matter.



4. REMOVE FLYWHEEL SUB-ASSEMBLY


A00JYQLE01

  1. Using SST, hold the crankshaft.

    SST
    09213-54015   (91651-60855)
    09330-00021  

  1. Remove the 8 bolts and flywheel.



5. REMOVE REAR END PLATE

  1. Remove the 2 bolts and rear end plate.



6. REMOVE FLYWHEEL HOUSING DUST SEAL


7. REMOVE REAR CRANKSHAFT OIL SEAL


    A00JU9TE03

  1. Using a knife, cut off the lip of the oil seal.
    Text in Illustration 
    *a
    		Cut Position

  1. Using a screwdriver, pry out the oil seal.

    ПРИМЕЧАНИЕ:
    After the removal, check that the crankshaft is not damaged. If damaged, repair it with a sandpaper (#400).

    УКАЗАНИЕ:
    Tape the screwdriver before use.