КОРПУС ДРОССЕЛЬНОЙ ЗАСЛОНКИ ДИЗЕЛЬНОГО ДВИГАТЕЛЯ > СНЯТИЕ

для подготовки Нажмите здесь



1. REMOVE RESONATOR WITH AIR CLEANER CAP SUB-ASSEMBLY


    A0098PV

  1. Disconnect the sensor connector.

  1. Detach the wire harness clamp.

  1. Loosen the hose clamp and remove the resonator with air cleaner cap.



    A0099K2

  1. Detach the 4 hook clamps, and then remove the air cleaner cap and resonator with air cleaner cap.



2. REMOVE INTAKE PIPE


    A0095CX

  1. Remove the 2 bolts.

  1. Loosen the hose clamp and remove the intake pipe.



3. REMOVE INTAKE FLANGE


    A00990QE01

  1. Remove the bolt and disconnect the heater water hose.
    Text in Illustration 
    *A
    		w/o Rear Heater
    *B
    		w/ Rear Heater



    A009AT6

  1. Disconnect the manifold absolute pressure sensor connector.



    A0094FR

  1. Disconnect the PCV hose.

  1. Remove the 3 nuts, intake flange and gasket.



4. REMOVE DIESEL THROTTLE BODY


    A0096IL

  1. Disconnect the throttle open switch connector.

  1. Disconnect the throttle control motor connector.

  1. Remove the diesel throttle body and gasket.