БЛОК СЦЕПЛЕНИЯ (для моделей с 5L-E) > УСТАНОВКА

для подготовки Нажмите здесь

1. Insert SST into the clutch disc. Then insert SST (together with the clutch disc) into the flywheel to install the clutch disc.
   

   SST

   09301-00110  
   

   Text in Illustration 

   Flywheel Side

   ПРИМЕЧАНИЕ:

   Be sure to install the clutch disc so that it is facing in the correct direction.

1. Align the matchmarks on the clutch cover and flywheel.
   

   Text in Illustration 

   *a

   Matchmark

2. Tighten the 6 bolts uniformly in the order shown in the illustration, starting with the bolt located near the knock pin on the top.
   

   SST

   09301-00110  
   

   Момент затяжки:

   19 N*m{ 194 kgf*cm , 14 ft.*lbf }

   УКАЗАНИЕ:

   Move SST up and down, and right and left lightly after checking that the clutch disc assembly is in the center, and then tighten the bolts.

1. Using a dial indicator with a roller instrument, measure the diaphragm spring tip alignment.
   

   SST

   09333-00013  
   

   Maximum non-alignment:

   0.5 mm (0.0196 in.)
   

   1. If the alignment is more than the maximum, use SST to adjust the diaphragm spring tip alignment.
      

1. Install the release fork support to the manual transmission unit.
   

   Момент затяжки:

   39 N*m{ 400 kgf*cm , 29 ft.*lbf }

1. Apply release hub grease to the clutch release bearing, and then install it to the clutch release fork with the clip.
   

   Grease:

   Toyota Genuine Release Hub Grease or equivalent
   

   Text in Illustration 

   *a	Release hub grease

1. Install the clutch release fork.
   

   ПРИМЕЧАНИЕ:

   After the installation, move the fork forward and backward to check that the release bearing slides smoothly.

2. Apply clutch spline grease to the spline of the input shaft.
   

   Grease:

   Toyota Genuine Clutch Spline Grease or equivalent
   

   Text in Illustration 

   *a	Clutch spline grease

1. Install the manual transmission assembly (See page Нажмите здесь).