СТАРТЕР > СНЯТИЕ

для подготовки Нажмите здесь



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

ПРИМЕЧАНИЕ:
  1. After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page Нажмите здесь).
  2. When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page Нажмите здесь).



2. REMOVE REAR ENGINE UNDER COVER ASSEMBLY

  1. Remove the 4 bolts and rear engine under cover.



3. DISCONNECT CLUTCH RELEASE CYLINDER ASSEMBLY


    A00JVD7

  1. Remove the 2 bolts and disconnect the release cylinder.



4. DISCONNECT CLUTCH FLEXIBLE HOSE BRACKET


    A00JZAT

  1. Remove the bolt and disconnect the clutch flexible hose bracket.



5. REMOVE STARTER ASSEMBLY


    A00K26R

  1. Disconnect the starter connector.

  1. Remove the terminal cap.

  1. Remove the nut and disconnect the starter wire.



    A00JY65

  1. Remove the nut, 2 bolts and starter.