СВЕЧА НАКАЛИВАНИЯ > СНЯТИЕ

для подготовки Нажмите здесь



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

ПРИМЕЧАНИЕ:
  1. After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page Нажмите здесь).
  2. When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page Нажмите здесь).



2. REMOVE RESONATOR WITH AIR CLEANER CAP SUB-ASSEMBLY


    A0098PV

  1. Disconnect the sensor connector.

  1. Detach the wire harness clamp.

  1. Loosen the hose clamp and remove the resonator with air cleaner cap.



    A0099K2

  1. Detach the 4 hook clamps, and then remove the air cleaner cap and resonator with air cleaner cap.



3. REMOVE INTAKE PIPE


    A0095CX

  1. Remove the 2 bolts.

  1. Loosen the hose clamp and remove the intake pipe.



4. DISCONNECT VENTILATION HOSE


    A00K0AT

  1. Disconnect the ventilation hose.



5. REMOVE NO. 1 GLOW PLUG CONNECTOR


    A00JTSS

  1. Remove the nut, No. 2 glow plug resistor insulator and washer and disconnect the wire harness.

  1. Remove the 4 screw grommets and 4 nuts.

  1. Remove the No. 1 glow plug connector and No. 1 glow plug resistor insulator.



6. REMOVE GLOW PLUG ASSEMBLY


    A00K050

  1. Using a 12 mm deep socket wrench, remove the 4 glow plugs.