DTC    17 (1)    Interior IC Malfunction

для подготовки Нажмите здесь


DESCRIPTION


DTC No.
DTC Detection Condition
Trouble Area
17 (1)
ECU malfunction.
ECM

INSPECTION PROCEDURE

УКАЗАНИЕ:
Read freeze frame data using the intelligent tester. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.

1.CHECK DTC OUTPUT (CHECK IF DTC 17 (1) IS OUTPUT AGAIN)

  1. Connect the intelligent tester to the DLC3.

  1. Clear the DTC (See page Нажмите здесь).

  1. Turn the ignition switch off for 30 seconds or more.

  1. Turn the ignition switch to ON and turn the tester on.

  1. Enter the following menus: Powertrain / Engine and ECT / DTC.

  1. Read the DTCs (See page Нажмите здесь).
    Result 
    Result
    		Proceed to
    DTC 17 (1) output again
    		A
    No DTC output
    		B



B
CHECK FOR INTERMITTENT PROBLEMS (Нажмите здесь)
A

REPLACE ECM (Нажмите здесь)