ВПУСКНОЙ КОЛЛЕКТОР > СНЯТИЕ

для подготовки Нажмите здесь



1. REMOVE INTAKE PIPE


    A0099HDE01

  1. Loosen the hose clamp and remove the 2 bolts and intake pipe.



2. REMOVE INTAKE FLANGE


    A009747

  1. Remove the bolt and disconnect the PCV hose and heater hose bracket.



    A009A45

  1. Disconnect the manifold absolute pressure sensor connector.



    A0095KM

  1. Remove the 3 nuts, intake flange and gasket.



3. REMOVE DIESEL THROTTLE BODY ASSEMBLY


    A00979C

  1. Disconnect the throttle open switch connector.

  1. Remove the 2 bolts and disconnect the wire harness bracket.



    A00947WE02

  1. Disconnect the throttle control motor connector.

  1. Remove the diesel throttle body and gasket.



4. REMOVE INJECTION PIPE


    A0095D6

  1. Using a 17 mm union nut wrench, loosen the 8 union nuts of the 4 injection pipes.

  1. Remove the 2 nuts, 2 upper pipe clamps and 4 injection pipes together with the 2 lower pipe clamps.



5. REMOVE INTAKE MANIFOLD


    A0094GI

  1. Remove the bolt and disconnect the wire harness bracket.



    A0099VA

  1. Remove the 6 bolts, 2 nuts, intake manifold and gasket.