УЗЕЛ ТОПЛИВНОГО БАКА > СНЯТИЕ

для подготовки Нажмите здесь



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

ПРИМЕЧАНИЕ:
  1. After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page Нажмите здесь).
  2. When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page Нажмите здесь).



2. REMOVE NO. 2 FUEL TANK PROTECTOR


    A00K0AW

  1. Remove the 5 bolts and No. 2 fuel tank protector.



3. DISCONNECT FUEL HOSE


    A00JUC2

  1. Disconnect the fuel evaporation hose, fuel breather hose and 2 fuel hoses.



4. DISCONNECT FUEL TANK TO FILLER PIPE HOSE


    A00JZJ8

  1. Disconnect the fuel tank to filler pipe hose from the filler pipe.



5. DISCONNECT FUEL TANK BREATHER HOSE


    A00JXBJ

  1. Disconnect the fuel tank breather hose from the filler pipe.



6. REMOVE FUEL SUB TANK SUB-ASSEMBLY


    A00K19N

  1. Disconnect the fuel sender gauge connector.

  1. Set a transmission jack underneath the fuel sub tank.



    A00JY1Y

  1. Remove the 4 bolts and disconnect the 2 fuel tank bands.

  1. Remove the fuel sub tank.



7. REMOVE FUEL TANK VENT TUBE ASSEMBLY


    A00JYR5

  1. Detach the wire harness clamp.

  1. Remove the 8 screws and fuel tank vent tube.

    ПРИМЕЧАНИЕ:
    Be careful not to bend the arm of the fuel sender gauge.

  1. Remove the gasket from the fuel tank vent tube.



8. REMOVE FUEL TANK TO FILLER PIPE HOSE


    A00JYBJ

  1. Remove the fuel tank to filler pipe hose from the fuel sub tank.



9. REMOVE FUEL TANK BREATHER HOSE


    A00JZGP

  1. Remove the fuel tank breather hose from the fuel sub tank.