ДАТЧИК АБСОЛЮТНОГО ДАВЛЕНИЯ В КОЛЛЕКТОРЕ > ПРОВЕРКА БЕЗ СНЯТИЯ С АВТОМОБИЛЯ

для подготовки Нажмите здесь



1. INSPECT MANIFOLD ABSOLUTE PRESSURE SENSOR


  1. Inspect the power source voltage.

    1. Disconnect the manifold absolute pressure sensor connector.



      2. A0094DKE01

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage:
      Tester Connection
      		Switch Condition
      		Specified Condition
      C83-3 (VC) - C83-1 (E)
      		Ignition switch ON
      		4.75 to 5.25 V

      Text in Illustration 
      *a
      		Front view of wire harness connector
      (to Manifold Absolute Pressure Sensor)
      If the result is not as specified, inspect the wire harness or ECM (See page Нажмите здесь).

    3. Connect the manifold absolute pressure sensor connector.



  1. Check the power supply.

    1. Turn the ignition switch to ON.

    2. Disconnect the vacuum hose from the manifold absolute pressure sensor.



      3. A0093Y4E01

    3. Using SST, measure the voltage according to the value(s) in the table below.

      SST
      09992-00242  

      Standard Voltage:
      Tester Connection
      		Condition
      		Specified Condition
      C102-2 (PIM) - C102-9 (E2)
      		60 kPa (0.61 kgf/cm2, 8.7 psi)
      		0.4 to 0.6 V
      87 kPa (0.89 kgf/cm2, 12.6 psi)
      		1.1 to 1.3 V

      Text in Illustration 
      *a
      		Component with harness connected
      (ECM)

      УКАЗАНИЕ:
      The values in the "Condition" column are gauge pressures.

      If the result is not as specified, replace the manifold absolute pressure sensor.