КОНТАКТНЫЙ ДАТЧИК ДАВЛЕНИЯ МАСЛА > ПРОВЕРКА

для подготовки Нажмите здесь



1. REMOVE ENGINE OIL PRESSURE SWITCH ASSEMBLY

  1. Disconnect the oil pressure switch connector.

  1. Start the engine.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    		Condition
    		Specified Condition
    1 - Body ground
    		Engine stopped
    		Below 1 Ω
    Engine idling
    		10 kΩ or higher

    If the result is not as specified, replace the oil pressure switch assembly.