БЛОК СЦЕПЛЕНИЯ (для моделей с 5L-E) > ПРОВЕРКА

для подготовки Нажмите здесь



1. INSPECT CLUTCH DISC ASSEMBLY


    A0097T4

  1. Using a vernier caliper, measure the rivet head depth.

    Minimum rivet head depth:
    0.3 mm (0.0118 in.)

    If the depth is less than the minimum, replace the clutch disc assembly.



    A009BGOE01

  1. Using a dial indicator, check the disc runout.

    Maximum runout:
    0.8 mm (0.0315 in.)

    ПРИМЕЧАНИЕ:
    Be sure to measure on the correct side of the clutch disc.

    If the runout is more than the maximum, replace the clutch disc assembly.



2. INSPECT CLUTCH COVER ASSEMBLY


    A009AOYE01

  1. Using a vernier caliper, measure the depth and width of the worn areas of the diaphragm spring.

    Maximum Wear:
    Item
    		Specified Condition
    Width
    		6.0 mm (0.236 in.)
    Depth
    		0.35 mm (0.0137 in.)

    Text in Illustration 
    *a
    		Width
    *b
    		Depth
    If the depth or width is more than the maximum, replace the clutch cover assembly.



3. INSPECT FLYWHEEL SUB-ASSEMBLY


    A00947NE01

  1. Using a dial indicator, measure the flywheel runout.

    Maximum runout:
    0.1 mm (0.00393 in.)

    If the runout is more than the maximum, replace the flywheel sub-assembly.



4. INSPECT CLUTCH RELEASE BEARING ASSEMBLY


    A009C2UE01

  1. Check that the bearing turns smoothly by hand by applying force in the axial direction.
    If the bearing sticks or has a considerable amount of resistance, replace the release bearing.

    УКАЗАНИЕ:
    The bearing is permanently lubricated and requires no cleaning or lubrication.



5. INSPECT INPUT SHAFT FRONT BEARING


    A0095GBE01

  1. Check that the bearing turns smoothly by hand by applying rotational force.
    If the bearing sticks or has a considerable amount of resistance, replace the input shaft front bearing.

    УКАЗАНИЕ:
    The bearing is permanently lubricated and requires no cleaning or lubrication.



6. REPLACE INPUT SHAFT FRONT BEARING

  1. Remove any 2 diametrically opposite bolts.



    A0094DDE01

  1. Using SST, remove the input shaft bearing.

    SST
    09303-35011  



    A0098BSE03

  1. Using SST and a hammer, tap in a new bearing.

    SST
    09304-12012  

    УКАЗАНИЕ:
    After installing the bearing to the hub, make sure that it rotates smoothly.

  1. Apply adhesive to 2 or 3 threads of the bolts.

    Adhesive:
    Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

  1. Install the 2 bolts.

    Момент затяжки:
    123 N*m{ 1249 kgf*cm , 90 ft.*lbf }