Length measurements are indicated at the points where the arrows extending from the zero point intersect the lines that extend towards the outside of the illustration from each point.
In cases in which only one dimension is given, left and right are symmetrical.
For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).
| Symbol | Name | Hole Diameter
mm (in.) |
|---|---|---|
| A, a | Front Crossmember Standard Hole | φ18 (0.71) |
| B, b | Front Suspension Crossmember Installation Nut | M16 (0.63) |
| C, c | Front Suspension Upper Arm Installation Hole | φ10.2 (0.40) |
| D, d | Front Spring Support Installation Hole | φ12.5 (0.49) |
| E, e | Front Suspension Upper Arm Installation Hole | φ10.2 (0.40) |
| F, f | Front Suspension Crossmember Installation Nut | M16 (0.63) |
| G, g | Torque Front No.2 Box Standard Hole | φ25 (0.98) |
| H, h | Front Side Member Reinforcement No.5 Standard Hole | φ13 (0.51) |
| J, j | Tank Band Installation Nut | M12 (0.47) |
| K, k | Front Side Member Reinforcement No.5 Standard Hole | φ18 (0.71) |
| L, l | Rear Floor Side Front Member Standard Hole | φ18 (0.71) |
| M, m | Rear Suspension Crossmember Installation Nut | M14 (0.55) |
| N, n | Rear Spring Support Installation Hole | φ13 (0.51) |
| O, o | Rear Suspension Crossmember Installation Nut | M14 (0.55) |
| P, p | Oil Cooler Installation Nut | M8 (0.31) |
| Wheel Base | 2920 mm (114.96 in.) |
| *a | mm
(in.) |
- | - |
| *a | Imaginary Datum Line | *b | Height from Imaginary Datum Line |
| *c | mm
(in.) |
- | - |