Home › Vehicle Exterior › BODY PANEL › ROCKER OUTER PANEL
BM37H0E _01 Vehicle Exterior _096506 BODY PANEL _0453129 ROCKER OUTER PANEL F

BODY PANEL  ROCKER OUTER PANEL  CUT AND JOIN REPLACEMENT SECTIONS  


K161006

REMOVAL


Symbol Meaning
K108818

Remove Weld Points
K108827

Cut and Join Location
K108828

Cut Location for Supply Parts

a.

Roughly cut open the panel so that the adhesive can be reached. Cut through the adhesive with a cut chisel to remove the panel.

HINT:

In cases where the adhesive cannot be removed with a cut chisel, heat the adhesive with an industrial heater gun or gas burner taking care not to cause panel deformation by overheating.


K160787C01
0,0 0,0 false
K108837

Adhesive - -


K160788C01
3.219,3.125 3.531,3.281 0.313,0.156 10 false *a
*a 75 mm (2.95 in.) - -


K160789



INSTALLATION


Symbol Meaning
K108823

Plug weld
K108831

Butt Weld

a.

Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.


b.

Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)


c.

Apply adhesive (3MTM AutomixTM Panel Bonding Adhesive #8115).

HINT:
·

Do not apply adhesive around the plug welding points.

·

Minimize squeeze out in plug welding areas.



K160787C01
0,0 0,0 false
K108837

Adhesive - -


K160790C01
3.333,4.417 3.5,4.417 3.5,4.417 3.063,3.875 false 3.156,4.344 3.469,4.5 0.313,0.156 10 false *1
*1 CENTER BODY PILLAR OUTER - -



d.

After welding, apply body sealer to the corresponding parts. (See the painting/coating)


e.

After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.