REMOVAL
| Symbol Meaning | |
|---|---|
|
Remove Weld Points |
INSTALLATION
| Symbol Meaning | |
|---|---|
|
Spot Weld |
|
Plug Weld |
|
Body Sealer |
Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.
Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)
Before temporarily installing the new parts, apply body sealer to the roof panel reinforcement no.6.
Apply enough adhesive to the panels.
| *A | Upper Face | - | - |
| *1 | ROOF PANEL REINFORCEMENT NO.6 | - | - |
Before temporarily installing the new parts, weld the roof panel rear and roof panel reinforcement no.6 with the standard number of welding points.
| *A | Upper Face | - | - |
| *1 | ROOF PANEL REAR | *2 | ROOF PANEL REINFORCEMENT NO.6 |
Before temporarily installing the new parts, apply body sealer to the back window frame.
Apply enough adhesive to the panels.
| *A | Upper Face | - | - |
| *1 | BACK WINDOW FRAME | - | - |
After welding, apply body sealer to the corresponding parts. (See the painting /coating)
After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.
| *A | Lower Face | - | - |
| Area | Measurement | Area | Measurement |
|---|---|---|---|
| A | 780 mm (30.71 in.) | B | 894 mm (35.20 in.) |
| C | 877 mm (34.53 in.) | - | - |