Home › Vehicle Exterior › ACOUSTIC VEHICLE ALERTING SYSTEM › ACOUSTIC VEHICLE ALERTING SYSTEM
NM37H0E _59 Vehicle Exterior _097151 ACOUSTIC VEHICLE ALERTING SYSTEM _0455047 ACOUSTIC VEHICLE ALERTING SYSTEM CO CONTROL F

ACOUSTIC VEHICLE ALERTING SYSTEM  ACOUSTIC VEHICLE ALERTING SYSTEM  CONTROL  ACOUSTIC VEHICLE ALERTING CONTROL  


FUNCTION OF MAIN COMPONENTS


Component Function
Vehicle Approaching Speaker Controller Starts, stops and controls the output sound according to input signals from various ECUs.
Vehicle Approaching Speaker Assembly Emits warning sounds based on an operation signal received from the vehicle approaching speaker controller.
EV Control ECU Sends the shift position signal, stop light switch signal and motor speed signal to the vehicle approaching speaker controller.
Combination Meter Assembly Multi-information Display Displays a warning message when there is a malfunction in the acoustic vehicle alerting system.
Brake Actuator Assembly Skid Control ECU No.2 Outputs a vehicle speed signal to the vehicle approaching speaker controller.
DLC3 The Global TechStream (GTS) can be connected to read the Diagnostic Trouble Codes (DTCs) of malfunctions.


OPERATING CONDITION


Condition Outline
System Active The acoustic vehicle alerting system operates (emits a warning sound) when all of the following conditions are met:
·

Shift position is any position other than P.

·

The vehicle speed is 25 km/h (16 mph) or less or the motor speed is 32 rpm or more, or the stop light switch is turned from on to off with a vehicle speed of 0 km/h and a motor speed of below 32 rpm.


System Stop The acoustic vehicle alerting system stops operating when any of the following conditions is met:
·

The vehicle speed is more than 25 km/h (16 mph).

·

Shift position is P.

·

With a vehicle speed of 0 km/h (0 mph) and a motor speed of below 32 rpm, the stop light switch is continuously on for approximately 0.24 seconds or more.

·

With a vehicle speed of 0 km/h (0mph) and a motor speed of below 32 rpm, the stop light switch is continuously off for approximately 3 seconds or more.*



HINT:

*: When the system is stopped due to a vehicle speed of 0 km/h (0 mph), a motor speed of below 32 rpm and the stop lights being off for approximately 3 seconds or more, the system operates again when the vehicle speed is 1 km/h (1 mph) or more, the motor speed is 32 rpm or more or the brake pedal is operated.



SYSTEM CONTROL


Control Outline
Vehicle Speed Linked Control
·

Controls the volume of the output sound according to the received vehicle speed.

·

The sound output when the vehicle speed is 0 km/h (0mph) is considered the original sound. During acceleration, the volume of the sound is increased, and during deceleration, the volume is decreased, outputting a sound that artificially reflects vehicle acceleration and deceleration.


Fade-in/Fade Out Control When the system starts operating, the warning sound volume gradually increases, and when system operation is stopped, the sound volume gradually decreases.
Control during Reverse Operation When the vehicle is being driven in reverse, the warning sound volume is controlled so that the sound is easy to hear even to the rear of the vehicle.


FUNCTION


a.

Warning Indication

i.

The combination meter assembly uses the multi-information display to notify the driver of acoustic vehicle alerting system malfunctions.


ii.

When the system is not available, the following warning occurs to warn the driver.

When a System Malfunction is Detected
Multi-information Display Detail Buzzer DTC
Acoustic Vehicle Alerting System Malfunction Visit your Dealer This message appears when the vehicle approaching speaker controller detects a system malfunction Sounds Repair is required DTCs are stored




DIAGNOSIS


a.

The vehicle approaching speaker controller also stores DTCs. The DTCs can be read by using the Global TechStream (GTS). For details, refer to the Repair Manual.