Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT › 2020.11–2021.08
NM37H0E _58 Vehicle Interior _097230 THEFT DETERRENT / KEYLESS ENTRY _0455370 THEFT DETERRENT CO CONTROL F

THEFT DETERRENT / KEYLESS ENTRY  THEFT DETERRENT  CONTROL  THEFT DETERRENT CONTROL  


FUNCTION


a.

The theft deterrent system has the following functions:

Function Operation

*: Models with panic alarm function

Alarm When the theft deterrent system switches to the alarm state, the warning items are operated and the alarm sounds for approximately 27.5 seconds.
Alarm Indicator When the theft deterrent system switches to the armed preparation state or alarm state, the security indicator light is illuminated to inform the user. This indicator is also the immobiliser indicator, which blinks when the immobiliser is in the set state.
Forced Door Lock The main body ECU transmits a door lock signal to all the doors when all the following conditions are met:
·

The theft deterrent system is in the alarm state.

·

There is no electrical key in the actuation area.

·

One of the doors has been unlocked.


The function stops when one of the following conditions is met:
·

All doors are locked.

·

The warning ends after approximately 27.5 seconds.

·

The electrical key is in the actuation area.


Panic Control* When the panic button of the electrical key is pressed, the main body ECU operates the alarm function.



OPERATION


a.

The states of the theft deterrent system are as follows:

State Description Theft Detection
Disarmed State The theft deterrent system has not been set by the user. Not possible
Armed Preparation State This is the preparation state before the theft deterrent system becomes active (enters the armed state) when the system has been set by the user. Not possible
Armed State The theft deterrent system is active. (Theft can be detected.) Possible
Alarm State A theft attempt has been detected and the warning operation activates. Possible

Y112351E06
1.75,1.49 3.01,1.667 1.26,0.177 10 false Disarmed State 1*1 5.042,1.49 6.302,1.667 1.26,0.177 10 false Disarmed State 2*2 2.385,3.208 4,3.385 1.615,0.177 10 false Arming Preparation State 2.792,4.615 3.604,4.792 0.813,0.177 10 false Armed State 2.49,6 3.896,6.177 1.406,0.177 10 false Alarm Sounding State 1.125,2.583 2,2.76 0.875,0.177 10 false Condition (3) 3.031,2.583 3.906,2.76 0.875,0.177 10 false Condition (1) 3.604,1.979 4.479,2.156 0.875,0.177 10 false Condition (9) 3.583,1.323 4.531,1.5 0.948,0.177 10 false Condition (10) 4.375,2.719 5.25,2.896 0.875,0.177 10 false Condition (8) 3.802,5.313 4.677,5.49 0.875,0.177 10 false Condition (4) 4.938,5.833 5.792,6.01 0.854,0.177 10 false Condition (7) 0.375,6.885 3.531,7.052 3.156,0.167 10 false *1: Disarmed state 1 is the normal disarmed state. 0.375,7.198 6.333,7.604 5.958,0.406 10 false *2: Disarmed state 2 is set from the disarmed state 1, the arming preparation state, the armed state or the alarm sounding state. 4.927,4.469 5.802,4.646 0.875,0.177 10 false Condition (7) 2.5,5.313 3.375,5.49 0.875,0.177 10 false Condition (6) 0.521,5.802 1.396,5.979 0.875,0.177 10 false Condition (5) 0.521,4.427 1.396,4.604 0.875,0.177 10 false Condition (5) 3.802,3.917 4.677,4.094 0.875,0.177 10 false Condition (2) 4.927,3.583 5.833,3.76 0.906,0.177 10 false Condition (11) 1.083,0.854 2.115,1.042 1.031,0.188 10 false Disarmed State


b.

The theft deterrent system activates as shown in the diagram above when one of the items in the table occurs in order to cause the system to enter the respective state.

HINT:

The term "all doors" used in this section refers to the driver door, front passenger door and luggage compartment door.


Models with Answer Back Buzzer Function
Condition Item
(1) In disarmed state 1, when the power source mode is off, the system state is switched if the following condition is met:
·

With all doors and the engine hood closed, all doors are locked by wireless operation, entry operation or key linked power door lock operation.

·

With all doors locked and the engine hood closed, the state changes from any of the doors being opened to all doors being closed.


(2) Allow approximately 30 seconds to elapse.
(3) One of the following conditions is met:
·

All doors are unlocked by wireless operation, entry operation or key linked power door lock operation*.

·

Any door is unlocked.

·

Any door is opened.

·

The power switch is pushed.

·

The power source mode is turned on (ACC) or on (IG).

·

The auxiliary battery is reconnected.


(4) One of the following conditions is met:
·

The engine hood is opened when the engine hood is closed.

·

The intrusion sensor detects movement within the vehicle.

·

Any door is opened when all doors are closed.

·

Any door is unlocked when all doors are locked not by wireless operation, entry operation or key linked power door lock operation*.

·

When 5 seconds or more have elapsed after the power switch is pressed, the power source mode is changed from off to on (IG) without pressing the power switch.

·

The auxiliary battery is reconnected when the engine hood is open, any door is open or any door is unlock.


NOTICE:

Ultrasonic waves are used to detect intrusion. Ultrasonic waves do not penetrate steel or glass. When any of the door windows is left open, ultrasonic waves may escape. This may result in the detection of people in the surroundings, leaves or insects entering the vehicle, strong wind or other ultrasonic wave sources in the environment when the vehicle is parked with the door windows open. When parking the vehicle with the door windows open for ventilation, turn off the intrusion sensor using the intrusion sensor cancel switch.*2


(5) One of the following conditions is met:
·

The power source mode is turned on (READY).

·

All doors are unlocked by wireless operation, entry operation or key linked power door lock operation*.

·

The power source mode is turned on (ACC) or on (IG) within 5 seconds after the power switch is pushed.


(6) After approximately 27.5 seconds, the alarm stops and the system returns to the armed state.
(7) The luggage compartment door is opened by wireless operation or entry operation.
(8) One of the following conditions is met:
·

The engine hood is closed with all the doors closed.

·

The luggage compartment door is closed with engine hood and all doors except for luggage compartment door closed.


(9) One of the following conditions is met:
·

Any door is unlocked when all doors are locked.

·

Any door is opened.

·

The power switch is pushed.

·

The power source mode is turned on (ACC) or on (IG).

·

The auxiliary battery is reconnected.

·

All doors are unlocked by wireless operation, entry operation or key linked power door lock operation*.


(10) In disarmed state 1, when the power source mode is off, the system state is switched if the following condition is met:
·

With all doors closed and the engine hood open, all doors are locked by wireless operation, entry operation or key linked power door lock operation.

·

With all doors closed except for the luggage compartment door, the engine hood closed and the luggage compartment door is open, all doors are locked by wireless operation, entry operation or key linked power door lock operation.


In disarmed state 1, when the power source mode is off and all doors are locked, the system state is switched if the following condition is met:
·

With engine hood closed and luggage compartment door open, the state changes from any of the doors being opened to all doors being closed.

·

With engine hood open and luggage compartment door closed, the state changes from any of the doors being opened to all doors being closed.


(11)
·

The engine hood is opened.

·

The luggage compartment door is opened by a wireless operation or entry operation.



HINT:

*: When disarming security with the mechanical key is turned on "ON" by the Global TechStream (GTS).


Models without Answer Back Buzzer Function
Condition Item
(1) In disarmed state 1, when the power source mode is off, the system state is switched if the following condition is met:
·

With all doors and the engine hood closed, all doors are locked by wireless operation or entry operation.


(2) Allow approximately 30 seconds to elapse.
(3) One of the following conditions is met:
·

All doors are unlocked by wireless operation, entry operation or key linked power door lock operation*1.

·

Any door is unlocked.

·

Any door is opened.

·

The power switch is pushed.

·

The power source mode is turned on (ACC) or on (IG).

·

The auxiliary battery is reconnected.


(4) One of the following conditions is met:
·

The engine hood is opened when the engine hood is closed.

·

The intrusion sensor detects movement within the vehicle.

·

Theft warning tilt sensor detects a change in the pitch angle of the vehicle inclination.*2

·

Any door is opened when all doors are closed.

·

Any door is unlocked when all doors are locked not by wireless operation or entry operation.

·

When 5 seconds or more have elapsed after the power switch is pressed, the power source mode is changed from off to on (IG) without pressing the power switch.

·

The auxiliary battery is reconnected when the engine hood is open, any door is open or any door is unlock.

·

The engine hood is open.

·

Any door is open.

·

The power source mode is on (IG).


NOTICE:

Ultrasonic waves are used to detect intrusion. Ultrasonic waves do not penetrate steel or glass. When any of the door windows is left open, ultrasonic waves may escape. This may result in the detection of people in the surroundings, leaves or insects entering the vehicle, strong wind or other ultrasonic wave sources in the environment when the vehicle is parked with the door windows open. When parking the vehicle with the door windows open for ventilation, turn off the intrusion sensor using the intrusion sensor cancel switch.


(5) One of the following conditions is met:
·

The power source mode is turned on (READY).

·

All doors are unlocked by wireless operation, entry operation or key linked power door lock operation*1.


(6) After approximately 27.5 seconds, the alarm stops and 5 seconds later the system returns to the armed state.
(7) The luggage compartment door is opened by wireless operation or entry operation.
(8) One of the following conditions is met:
·

The engine hood is closed with all the doors closed.

·

The luggage compartment door is closed with engine hood and all doors except for luggage compartment door closed.


(9) One of the following conditions is met:
·

Any door is unlocked when all doors are locked.

·

Any door is opened.

·

The power switch is pushed.

·

The power source mode is turned on (ACC) or on (IG).

·

The auxiliary battery is reconnected.

·

All doors are unlocked by wireless operation, entry operation or key linked power door lock operation*1.


(10) In disarmed state 1, when the power source mode is off, the system state is switched if the following condition is met:
·

With all doors closed and the engine hood open, all doors are locked by wireless operation or entry operation.

·

With all doors closed except for the luggage compartment door, the engine hood closed and the luggage compartment door is open, all doors are locked by wireless operation or entry operation.


(11)
·

The engine hood is opened.

·

The luggage compartment door is opened by a wireless operation or entry operation.



HINT:

*1: When disarming security with the mechanical key is turned on "ON" by the Global TechStream (GTS).

*2: Models with tilt sensor