Home › Brake › PARKING BRAKE › ELECTRIC PARKING BRAKE SYSTEM
NM37H0E _54 Brake _097288 PARKING BRAKE _0455633 ELECTRIC PARKING BRAKE SYSTEM DE DETAILS F

PARKING BRAKE  ELECTRIC PARKING BRAKE SYSTEM  DETAILS  TENSION SENSOR  


CONSTRUCTION


a.

A Hall IC type tension sensor is used. This sensor is connected to the equalizer in order to detect the tension of the parking brake cable.


b.

When the equalizer is pulled to the left (as shown in the illustration below) due to the motor operating, the shaft and built-in magnet are also moved in the same direction.


c.

When the shaft is moved to the left, the case is moved in the same direction via the springs. Thus, the parking brake cable is pulled.


d.

The springs compress in accordance with the tension acting on the parking brake cable, causing the positions of the case and magnet to change. As a result, the magnetic flux density changes. Hall ICs detect changes in the magnetic flux density, convert those changes into electrical signals, and then transmit them to the No. 2 skid control ECU. Based on the signals received from Hall ICs, the No. 2 skid control ECU calculates the tension of the parking brake cable.

X106526C01
2.344,1.646 1.5,1.646 true 5.083,2.354 4.729,2 true 5.094,1.229 4.74,0.865 true 4.792,0.354 4.448,0.604 true 4.094,0.313 3.865,0.708 true 3.969,1.375 3.813,0.896 true 3.344,1.375 3.24,1.073 true 3.229,0.646 3.125,0.344 true 3.135,0.771 2.688,0.396 true 1.323,1.563 1.688,1.958 0.365,0.396 10 false *1 5.146,2.323 5.51,2.635 0.365,0.313 10 false *2 5.135,1.198 5.5,1.51 0.365,0.313 10 false *2 4.771,0.188 5.135,0.5 0.365,0.313 10 false *3 4.042,0.115 4.406,0.427 0.365,0.313 10 false *4 3.938,1.427 4.302,1.74 0.365,0.313 10 false *5 3.281,1.406 3.646,1.719 0.365,0.313 10 false *6 3.031,0.135 3.396,0.448 0.365,0.313 10 false *6 2.531,0.26 2.896,0.573 0.365,0.313 10 false *7
*1 Equalizer *2 Parking Brake Cable
*3 Case *4 Spring
*5 Shaft *6 Hall IC
*7 Magnet - -