Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM
NM37H0E _59 Vehicle Exterior _097228 LIGHTING (EXT) _0455766 LIGHTING SYSTEM CO CONTROL F

LIGHTING (EXT)  LIGHTING SYSTEM  CONTROL  AUTOMATIC LIGHT CONTROL  


FUNCTION OF MAIN COMPONENTS


Component Function
Headlight ECU Sub-assembly RH Receives headlight control signal and supplies power to the headlights and clearance lights.
Headlight ECU Sub-assembly LH
No. 2 Semiconductor Power Integration ECU Supplies power to the taillights and license plate lights.
Turn Signal Switch Light Control Switch Sends the light control switch position signal to the steering sensor.
Steering Sensor Sends the light control switch position signal to the main body ECU.
Main Body ECU (Multiplex Network Body ECU) Receives various signals and illuminates the headlights, clearance lights, taillights and license plate lights.
Automatic Light Control Sensor Detects the ambient light level and transmits a signal to the main body ECU.
Front Door Courtesy Light Switch Assembly LH / RH Detects whether a door is open or closed and sends the signal to the main body ECU.
Certification ECU (Smart Key ECU Assembly) Sends ignition switch condition signals to the main body ECU.
Multi-display Assembly Displays the settings screen.
Central Gateway ECU (Network Gateway ECU) Relays the signal between the CAN communication lines.


SYSTEM CONTROL


a.

Operating Condition

i.

The automatic light control system operates as follows:

Function Outline
Headlights and Taillights Turn On When all of the following conditions are met, the headlights, clearance lights, taillights and license plate lights automatically turn on:
·

The ambient light is dark or momentarily bright*.

·

The ignition switch is on (IG).

·

The light control switch is in the AUTO position.


Headlights and Taillights Turn Off When the ambient light is bright, the exterior lights automatically turn off.

HINT:

*: The sensitivity of the automatic light control sensor can be changed on the settings screen of the multi-display assembly.





FUNCTION


a.

The automatic light control function settings can be changed on the setting screen of the multi-display or using the Global TechStream (GTS). For details, refer to the Repair Manual.