Home › Power Source / Network › BATTERY / CHARGING › CHARGING SYSTEM
NM37H0E _57 Power Source / Network _097453 BATTERY / CHARGING _0456738 CHARGING SYSTEM DE DETAILS F

BATTERY / CHARGING  CHARGING SYSTEM  DETAILS  BATTERY SENSOR  


CONSTRUCTION


a.

The battery state sensor assembly is installed to the negative (-) battery terminal side of the auxiliary battery. The battery state sensor assembly calculates the current, voltage, temperature, SOC (battery charging rate) and SOH (battery deterioration level), and sends signals to the EV Control ECU via the LIN communication.


b.

To detect the current of the auxiliary battery, a shunt resistor installed inside the battery state sensor assembly is used to convert the voltage that is generated in the shunt resistor due to the battery charge and discharge current and calculate the current.


c.

The auxiliary battery temperature is calculated from the resistance value of the thermistor built into the battery state sensor assembly.

W136333E26
0.573,3.354 2.625,3.594 2.052,0.24 10 false : LIN communication line 2.104,1.042 2.594,1.292 0.49,0.25 10 false IC Chip 4.167,0.552 5.281,0.927 1.115,0.375 10 false EV Control ECU 5.198,3.365 6.292,3.615 1.094,0.25 10 false Auxiliary Battery 1.521,2.802 3.531,3.104 2.01,0.302 10 false Battery State Sensor Assembly 1.875,2.344 2.854,2.635 0.979,0.292 10 false Shunt Resistor