CONSTRUCTION
A air-cooled type oil cooler and oil pump with motor assembly provided to ensure the ATF cooling performance. By reducing the increase in oil temperature at high loads, such as during sporty driving, enhanced reliability has been achieved.
ATF is pressure-fed to the oil pump with motor assembly through the oil cooler assembly and then the cooled ATF is supplied from the upper transaxle through the lower return line. This motor cooling system is used to achieve enhanced high output motor cooling performance.
| *1 | Oil Pump with Motor Assembly | *2 | Oil Cooler Assembly |
|
ATF Flow | - | - |
The motor cooling adopted a 2-system structure that uniformly cools the motor stator sub-assembly with ATF, which is cooled via the motor cooling cooler, by using a structure that directly pours the fluid on from above and the centrifugal force rotation of the No. 2 motor cooling pipe. Cooling performance improvements were measured as well.
| *1 | Motor Stator Sub-assembly | *2 | No. 2 Motor Cooling Pipe |
|
Directly Pours Fluid on from Above |
|
No. 2 Motor Cooling Pipe Cooling |
A differential pressure air flow guiding method is used to ensure ATF cooling performance achieved through the use of an FCV transaxle installed on the rear and an air-cooled type oil cooler.
The pressure under the vehicle is decreased while driving, which causes a differential pressure with the rear of the vehicle, resulting in the air flow to the transmission oil cooler air duct.
| *1 | Transmission Oil Cooler Air Duct LH | *2 | Oil Cooler Assembly |
| *3 | Transmission Oil Cooler Under Cover LH | *4 | Transmission Oil Cooler Under Cover RH |
| *5 | Transmission Oil Cooler Air Duct | - | - |
| *a | Air Flow | *b | Air Flow Under Vehicle |
| *c | Low Pressure | *d | High Pressure |