CONSTRUCTION
A intrusion sensor is provided in the map light assembly.
If the intrusion sensor detects an inappropriate entry into the vehicle interior, a warning signal is sent to the main body ECU.
The intrusion sensor is composed of a transmission sensor that transmits ultrasonic waves and a receiving sensor that receives reflected waves.
The intrusion sensor detects intruders by sending an ultrasonic wave and detecting differences in the frequency of the reflected wave.
Ultrasonic waves used to detect intrusions do not penetrate steel body panels or glass. However, when any window or the sliding roof is open, ultrasonic waves leak outside the cabin. Therefore, when the vehicle is parked with any window or the sliding roof open, the intrusion sensor may detect people approaching the vehicle, leaves entering the cabin, insects, strong wind or ultrasonic waves from the outside. In situations such as when the vehicle is parked with any window or the sliding roof open for ventilation, stop operation of the intrusion sensor with the intrusion sensor cancel switch before parking the vehicle.
| *1 | Map Light Assembly | *2 | Intrusion Sensor (Theft Warning Ultrasonic and Tilt Sensor) |
| *a | Transmission Sensor | *b | Receiving Sensor |
OPERATION
The intrusion sensor, which is linked to the theft deterrent system, is set automatically when the system transfers to the armed state (and the setting of the theft deterrent system is completed).
When the intrusion sensor detects a moving object in the vehicle, the system transfers to the alarm sounding state. Then, the system sounds the horns and theft warning siren intermittently, blinks the hazard warning lights for approximately 27.5 seconds and performs a forced locking operation.
When in glass breakage detection mode, ultrasonic waves are not transmitted from the transmission sensor and only the receiving sensor for detecting glass breakage is operated. When in moving object detection mode, ultrasonic waves are transmitted from the transmission sensor and reflected waves are received by the receiving sensor. If there are differences between the frequencies when waves are received and transmitted, the presence of a moving object is detected inside the vehicle. (Models with glass breakage detection mode)