Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › BRAKE CONTROL SYSTEM
NM37H0E _54 Brake _097284 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0466235 BRAKE CONTROL SYSTEM CO CONTROL F

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  BRAKE CONTROL SYSTEM  CONTROL  SECONDARY COLLISION BRAKE  


SYSTEM CONTROL


a.

The secondary collision brake system contributes to a reduction in damage from secondary collisions by controlling the automatic brakes and stop light illumination after a collision occurs.


b.

When the airbag ECU assembly detects a collision and operates the airbags, it sends a collision detection signal to the No. 2 skid control ECU. When the No. 2 skid control ECU receives a collision detection signal, it determines that operation can start, operates the brake actuator and performs braking. Simultaneously, the No. 2 skid control ECU sends a stop light illumination request to the No. 2 semiconductor power integration ECU, illuminating the stop lights.

X148420E04
0.479,0.844 2.031,1.302 1.552,0.458 10 false Airbag ECU (Airbag ECU Assembly) 0.75,1.729 1.958,2.156 1.208,0.427 10 false EV Control ECU 0.25,2.677 2.208,3.177 1.958,0.5 10 false Central Gateway ECU (Network Gateway ECU) 3.135,0.177 4.094,0.802 0.958,0.625 10 false Brake Actuator Assembly 0.313,3.823 2.354,4.094 2.042,0.271 10 false Combination Meter Assembly 3.271,2.031 3.958,2.677 0.688,0.646 10 false No. 2 Skid Control ECU 0.635,4.354 2.75,4.615 2.115,0.26 10 false : CAN communication line 5.792,3.958 6.833,4.333 1.042,0.375 10 false Stop Light 5.208,2.365 6.969,2.885 1.76,0.521 10 false No. 2 Semiconductor Power Integration ECU 5.563,1.271 6.885,1.583 1.323,0.313 10 false Speed Sensor (4) 4.354,2.792 5.073,3.542 0.719,0.75 10 false Stop Light Illumination Request Signal 6.135,3.271 6.865,3.792 0.729,0.521 10 false Stop Lights Illumination 4.458,1.479 4.896,2.125 0.438,0.646 10 false Wheel Speed Signal

i.

Secondary Collision Brake Operation Start Condition

·

When a collision detection signal is received from the airbag ECU while the vehicle speed is approximately 10 km/h or more, the secondary collision brake starts operating.

HINT:

When a system malfunction is displayed on the multi-information display or the system is in test mode or maintenance mode, the secondary collision brake is prohibited from operating.




ii.

Secondary Collision Brake Operation Cancellation Condition

·

If one of the following conditions is detected, operation of the secondary collision brake is canceled.

Secondary Collision Brake Operation Cancellation Conditions
·

The vehicle speed is below approximately 10 km/h.

·

Operation continues for a certain period of time.

·

After operating, the accelerator pedal is depressed a certain amount or more.