OUTLINE
The Toyota parking assist-sensor system uses ultrasonic sensors to detect stationary objects in front of, at the corners, at the sides*1 or to the rear of the vehicle.
The Toyota parking assist-sensor system informs the driver of the approximate distance between the ultrasonic sensors and any stationary objects as well as their positions by displaying them on the multi-information display in the combination meter assembly, headup display*2 and multi-display assembly*3 or radio and display receiver assembly*4 and by sounding the No. 1 clearance warning buzzer and No. 2 clearance warning buzzer.
When each clearance warning buzzer sounds due to the detection of an obstacle, the buzzer can be temporarily muted by operation of the multi-information display in the combination meter assembly.
An object warning function is used where the ultrasonic sensors and side cameras installed on the sides of the vehicle to the front and rear scan the sides of the vehicle when driving at low speeds, the positions of any detected stationary objects are calculated, allowing to determine if the vehicle is approaching a stationary object to the side that could not be detected directly by the ultrasonic sensors and side cameras. The driver is also notified of the distance to the stationary object and its level of danger through both audible and visual means from the multi-information display, multi-display assembly or headup display*2.*1
*1: Models with advanced park
*2: Models with headup display
*3: Models with multi-display assembly
*4: Models with radio and display receiver assembly
PRECAUTION
The detection range of the sensor is limited to around the bumpers. When driving the vehicle in forward or reverse, be sure to confirm visually that the area around the vehicle (especially on the sides of the vehicle) outside the sensor detection area is safe, use the brakes to control the vehicle speed and drive slowly.
Notifications may not be displayed or sounded depending on the stationary object. Be careful not to make contact.
If the sensor is covered with mud or snow, the Toyota parking assist-sensor system will not operate normally and could lead to an unforeseen accident. Remove foreign matter from the sensor.
If the bumper is damaged, the equipment may not operate normally due to a sensor malfunction.
Do not install any accessories within the detection range of the sensor. The Toyota parking assist-sensor system will not operate normally and could lead to an unforeseen accident.
The shape and condition of the stationary object may reduce the detection distance or prevent detection. Be sure to confirm visually that the area around the vehicle (especially on the sides of the vehicle) outside the sensor detection area is safe, use the brakes to control the vehicle speed and drive slowly.
Under the following conditions, the detection function may not operate properly:
The sensor is frozen. (The sensor will function normally when defrosted) If the sensor freezes at a low temperature, the display may malfunction or stationary objects may not be detected.
The sensor is covered by a hand, or covered with foreign matter, such as mud or snow. (The sensor will function normally when the foreign matter is removed)
The detection distance may be reduced due to objects such as signs.
The sensor cannot detect an object directly under the bumper. The sensor may not detect objects that are lower than the sensor or thin stakes and similar objects as they approach, even if they have been detected already.
The sensor may be unable to detect stationary objects if it is too close to the objects.
The detection range may be affected by the following conditions:
The sensor is covered with foreign matter, such as mud or snow.
In blazing heat or freezing cold.
The following situations may result in a false detection:
Driving on a bumpy road, unpaved road, slope or grass.
There is an audio source nearby emitting ultrasonic waves, such as another vehicle's horn, motorcycle engine, large vehicle air brakes or ultrasonic noise from another vehicle with sonar equipped.
Heavy rain or water is sprayed on the sensor.
A tow hook is installed.
A high-output wireless antenna is mounted to the vehicle body.
The vehicle is significantly tilted.
The sensor is covered with mud or snow.
The vehicle is driving toward a high curb or the edge of a curb.
The following objects may not be detected:
Thin objects such as wire, rope or a fence.
Materials that absorb sound waves, such as sponge, snow or cotton.
Acute-angled objects.
Short objects.
Tall objects where the top sticks out.
Some people may also not be detected due to their clothing.
Under the following conditions, the object warning function may not function properly: (Models with Advanced Park)
There is a small vehicle or stationary object next to the vehicle that cannot be detected by the front side sensor when starting off immediately after the power source mode is turned on (IG).
There is a stationary object or person in a position that cannot be detected by the side sensor or side camera.
A vehicle, person or animal enters the side area from the side of the vehicle, even after the side area is scanned.
Other
The Toyota parking assist-sensor warning sound may be inaudible depending on the audio volume or air flow volume from the air conditioner.
Be careful that water does not become concentrated around the sensor when using a car wash that uses steam or high pressure water. Maintain as much distance as possible during use.