CONSTRUCTION
The No. 1 clearance warning buzzer is installed in the instrument panel. The sound pattern of the buzzer changes when a stationary object is detected in front of the vehicle to notify the driver of the approximate distance of the object from the vehicle.
The No. 2 clearance warning buzzer is installed on the rear inside the vehicle. The sound pattern of the buzzer changes when a stationary object is detected behind the vehicle to notify the driver of the approximate distance of the object from the vehicle.
Sounding of the No. 1 clearance warning buzzer and No. 2 clearance warning buzzer is controlled by the clearance warning ECU assembly.
| Item | Specification | |
|---|---|---|
| No. 1 Clearance Warning Buzzer | Operation Frequency [kHz] | 2.4 +/- 0.04 |
| Sound Pressure Level [dB]* | 80 +/- 6 | |
| No. 2 Clearance Warning Buzzer | Operation Frequency [kHz] | 2.0 +/- 0.04 |
| Sound Pressure Level [dB]* | 91 +/- 6 | |
*: This is the sound pressure level at a position 1 m (3.28 ft.) away from the buzzer itself, not the level where the driver would be sitting (where the sound would actually be heard).
OPERATION
Clearance Warning Buzzer Sounding
If an obstacle is detected at longest range, long-range or medium-range, the buzzer sounding interval changes approximately every 100 mm (3.94 in.)*1 or 100 - 150 mm (3.94 - 5.91 in.)*2 according to the distance from the object, and the clearance warning buzzer sounds.
If an obstacle is detected at short-range or shortest range, the clearance warning buzzer sounds continuously.
*1: Models without advanced park
*2: Models with advanced park
If both a front sensor and rear sensor detect an object at the same time, both the No. 1 and No. 2 clearance warning buzzers sound independently (based on the front detection distance for No. 1 and the rear detection distance for No. 2).