Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM
NM37H0E _58 Vehicle Interior _097853 HEATING / AIR CONDITIONING _0466362 AIR CONDITIONING SYSTEM CO CONTROL F

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM  CONTROL  REMOTE AIR CONDITIONING CONTROL  


FUNCTION OF MAIN COMPONENTS


Component Function
Air Conditioning Amplifier Assembly Controls the remote air conditioning system based on the signals from the ECUs
EV Control ECU
·

Checks the vehicle condition (shift position, etc.) and judges whether to prohibit or permit remote air conditioning.

·

Turns SMR ON and starts the FC system in order to operate the remote air conditioning.


Main Body ECU (Multiplex Network Body ECU) The key control signal and vehicle state which certification ECU received (door hood states) is transmitted to air conditioner amplifier assembly.
DCM (Telematics Transceiver) Receives remote air conditioning operation signals from a smartphone and sends the information to the air conditioning amplifier assembly.


SYSTEM CONTROL


a.

It is possible for the remote air conditioning system to be started when all of the following conditions are met:

·

All doors are closed.

·

Hood is closed.

·

The power switch is not being pressed.

·

The alarm system is not sounding.

·

2.5 seconds have elapsed since the power switch was pressed.

·

Park (P) is selected.

·

All doors are locked when the remote air conditioning system is started using a smartphone or the climate prep function.



b.

Operation of the remote air conditioning system will be suspended if either of the following conditions are met:

·

Approximately 20 minutes have elapsed since the remote air conditioning system started.

·

Operation is stopped via a smartphone.

·

Any condition required to start the remote air conditioning system is not met (any door is open, the hood is open, etc.)

·

Fuel level became low



c.

When operation of the remote air conditioning system starts, the air conditioning system judges the cycle mode (cooler mode/heater mode/defrosting mode). When heater mode is selected and the external condenser (cooler condenser assembly) is frozen, defrosting mode starts.